In my case it was low voltage terminal block issue.... if you move it up-down, powers up ... soldering on the back was loose
Hello,
I’m just curious I installed this Goodman GMES801005CNAA Furnace in and it’s not even 3yrs old and I went to do my annual clean & check on it and the board was bad! I had 120v power going to the board and 24v going to the board but it wouldn’t power up! So luckily the furnace was still under warranty and I replaced the board and the furnace fired up. I check the board to see if there was any burnt marks and there was none. I just wanted to know if anyone experience this with this particular model?
Thanks!
In my case it was low voltage terminal block issue.... if you move it up-down, powers up ... soldering on the back was loose