Results 1 to 2 of 2

Thread: Question about replacing CO sensor in Testo 327-1

  1. #1
    Join Date
    Sep 2008
    Location
    VA
    Posts
    4,631
    Post Likes

    Question about replacing CO sensor in Testo 327-1

    While debating the purchase of a new analyzer I may go ahead and replace my 327’s CO sensor.

    So, reading the manual it says you have to input the “cell coefficients”, but in my adjust menu it only gives an O2 calibrate selection. There’s no “CO” option in the adjust menu. Is it necessary to input the coefficient with the newer firmware and updated sensor? I’m running V1.18.
    "The only true wisdom is in knowing you know nothing" Socrates

  2. #2
    Join Date
    Sep 2008
    Location
    VA
    Posts
    4,631
    Post Likes
    Thread Starter
    Did Testo intentionally remove this option to force you to send it in to have it replaced, or am I missing something? They claim field replaceable pre-calibrated sensors.
    "The only true wisdom is in knowing you know nothing" Socrates

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •