Is everything normal?

 

*

 

No, nothing is normal on this one, lol the condenser is 6 inches off the wall all the evaporators in side were clogged and the install was sub par. But I think I’m back to where I could start to diagnose things.
I would love to reclaim the ref. In it. weigh it out a new charge and move the condenser off the wall another 1’ but then how would I measure the extra line set behind the walls. It would be impossible with out ripping out sheet rock.

 

Suction side pressure 300

 

Pump it down and triple vac. But then I’m afraid I’m just going to find a sticky txv and have to replace the whole rack inside the condenser.

 

I’m new here like this morning new , still trying to figure out this site , I apologize in advance

 

What is an AOP

 

Ask or Professionals.

If your in the trade this is the place.

Whats wrong with 6" off the wall? With the wall mount brackets thats about all you get.

We still need Make and Model

 

With it being six inches off the wall- the problem with that is air flow and being able to clean the coils and visually inspect them. On top of that the install manual wants over 20 inches with a multi zone system that’s doing heat too.
The make is a YMGI wmms 60 ch (59)2

 

I’m in the trades master plumber NH, MA, EPA CERT. mass lic. Oil burner last project was a 4 condenser job on 11 Taylor St , Littleton ma.
All Mitsubishi hyper heat

 

So I’m in the wrong place sorry I’ll try again after work

 

I thought I was in tech to tech

 

[emoji897]

Sent from my LM-G820 using Tapatalk

 

It is in tech to tech

 

Awesome