got power anywhere else?

 

With no documentation I did a few things to get started.
Power supply outputs were 5vdc \12 vdc
I unplugged each input and output on the micro and tried to reboot. no success.
i have since printed off the optiview manual(160.55M-1)and scoured this site for more info.
I need to pay close attention to the actual power supply voltages.
I also need a wiring diagram for this panel.
with a green led im assuming the LCD should be lit up.

 

is the display lamp getting its DC voltage?

 

You need to take this question to the Pro's forum. I'd try to help, but not here in the open forum.

 

Agree take it to the Pro Forum.

 

I might add that many of the answers are in the manual I sent you. Pages 34-35 should be helpful.

 

i was able to resolve the issue.
should we discuss in pro?
start a new thread?

 

turned out to be a bad J1 plug connection on the main board from the power supply.
used a tip cleaner plugged here back in and away she went.
cycled power off a dozen times, came back up without fail.
had the office order a new plug.
thanks to all