Reply@ngb20
As the moderators to move this to the controls forum.
New Guest
Good afternoon,
I just have a couple questions about editing a control program. We have ChillerVu controller, in which we need to make a slight change to the control logic. After downloading the program from the server, we are able to modify it in SNAP to our needs. However, the network addresses and I/O points do not match what is currently running in I-VU. If any changes are made to microblock properties in I-VU after upload, does the .equipment file not get changed as well or is there a translation step we are missing? Also, does the controller restart when a new program is implemented?
Thank you for any information!
Professional Member*
@ngb20
As the moderators to move this to the controls forum.
If sense were so common everyone would have it !You cannot protect the Stupid from themselves !"Experience is the ability to recognize a mistake Before you make it again!" (Stolen Quote)
