Hanging out with the mice behind the fridge talking bad about the roaches in the oven.
Posts
31,873
Post Likes
Likes (Given)
51114
Likes (Received)
14501
Dislikes (Given)
0
Dislikes (Received)
25
Was the compressor still alive?
Sent from the Okie state usin Tapatalk
"Is this before or after you fired the parts cannon at it?" - senior tech
I'm tired of these mediocre "semi flammable" refrigerants. If we're going to do it let's do it right.
Unless we change direction we are likely to end up where we are going.
"It's not new, it's better than new!" Maru.
Grainy photo, but is that suction line insulation fairly new?
Ha! You might be on to something. It's a lot easier to insulate that suction line when that stupid thing-a-ma-jiggy isn't in the way. There... That's way better!
If at First You Don't Succeed, Skydiving Is Not for You.
Hanging out with the mice behind the fridge talking bad about the roaches in the oven.
Posts
31,873
Post Likes
Likes (Given)
51114
Likes (Received)
14501
Dislikes (Given)
0
Dislikes (Received)
25
Maybe they did that to try to get a txv that was running out of bulb charge to open enough.
Sent from the Okie state usin Tapatalk
"Is this before or after you fired the parts cannon at it?" - senior tech
I'm tired of these mediocre "semi flammable" refrigerants. If we're going to do it let's do it right.
Unless we change direction we are likely to end up where we are going.
"It's not new, it's better than new!" Maru.
Maybe they did that to try to get a txv that was running out of bulb charge to open enough.
Sent from the Okie state usin Tapatalk
We used to have a unit at work that the bulb was pulled out of the cabinet for that reason till we could get a replacement for that reason ..... weirdly it took a couple years till it was replaced. When it was finally pulled the strainer was mostly plugged.
I had one were the bulb was in the coil cabinet in the supply air stream. Rhe owner saud they did alot of commercial refrigeration????? and not know how to hook up an expansion valve?
Plenty of thermal conductivity with a cable tie, too!
********* https://www.hvac20.com/ High efficiency equipment alone does not provide home comfort and efficiency. HVAC2.0 is a process for finding the real needs of the house and the occupants. Offer the customer a menu of work to address their problems and give them a probability of success.
Find contractors with specialized training in combustion analysis, residential system performance, air flow, and duct optimization https://www.myhomecomfort.org/
Reply
Professional Member
Lahrs liked this post.
Professional Member*
Originally Posted by AIRCON8
