Hi everyone. I got a reach in cooler they say won’t get cold enough. Mn. 8395N sn. W112946-1. With condenser. M4PF-0050-1aa-140. Kicks on at 43° off at 32° with no product. Stat at 9. Need a service manual.
If it is..those cap tubes like to plug on the inside.
Makes the coil get too cold and itll cycle off too soon.
Ive seen that few times …. the stats sensor will be located right where the cap tube enters and that 2 inch section will be frosty , and the rest 80 % of coil is barely cool
Ive seen that few times …. the stats sensor will be located right where the cap tube enters and that 2 inch section will be frosty , and the rest 80 % of coil is barely cool
Its partially a shitty design.
Their idea of separate cold rail and box control is great. But...
Its severely offset by them using generally a low temp condensing unit, too small of condenser coil space, shitty mullion evap design and if they have drawers it will block 80% of the airflow...
If they woulda went with extended temp condensing units or heck maybe just larger condenser coils (like delfield units), and put some beefy fans inside, then they woulda been pretty good units.