Page 2 of 2 FirstFirst 12
Results 14 to 19 of 19
  1. #14
    Join Date
    Sep 2002
    Posts
    26,307
    Post Likes
    I would have hard-piped that lineset so pretty no one would Want to conceal it.

    And tidied up the sealtite to match. <g>

    PHM
    ------



    Quote Originally Posted by chrisevansac View Post



    Sent from my iPhone using Tapatalk
    PHM
    --------
    The conventional view serves to protect us from the painful job of thinking.

  2. #15
    Join Date
    Feb 2011
    Location
    Georgia
    Posts
    722
    Post Likes
    Thread Starter
    This was a $400k house under contract in Atlanta. Home inspector already gave the ok on everything and recommended an hvac company service it.


    Sent from my iPhone using Tapatalk

  3. #16
    Join Date
    Jan 2014
    Location
    New England
    Posts
    5,977
    Post Likes
    Quote Originally Posted by BBeerme View Post
    Hey, hey, hey now, quit slamming my work. Had nothing to do with too many beers. The fact is I ran out of beer, so I couldn't stay there and take my time and make it look prettier. No store for 50 miles, found that gutter in the guys barn, and quote said to hide the lineset, so I complied. Had to drive home so I could get really get my fill of brewskies.
    Hey that’s pretty good,...I’ll give you a full like. Yes the support brackets alignment on the downspout is pretty good. I like that part.

  4. #17
    Join Date
    Feb 2014
    Posts
    17
    Post Likes
    I bet it says Goodman on the front of that unit

  5. Likes chrisevansac liked this post
  6. #18
    Join Date
    Oct 2014
    Location
    Saint Pail, Minnesota
    Posts
    683
    Post Likes
    Quote Originally Posted by Gwing21 View Post
    I bet it says Goodman on the front of that unit
    It most likely does, since that is the manufacturer.

  7. #19
    Join Date
    May 2014
    Location
    Bay Area California
    Posts
    24,506
    Post Likes
    Quote Originally Posted by Bazooka Joey View Post
    Hey that’s pretty good,...I’ll give you a full like. Yes the support brackets alignment on the downspout is pretty good. I like that part.
    If you were a real tech, you'd solder a relay on that board and call it good to go.

    I do a triple evac with nitro to remove non condensables.

    I use 56% silver on everything except steel.

    Did you really need the " If you were a real tech " ??

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •