Results 1 to 4 of 4
  1. #1
    Join Date
    Oct 2019
    Posts
    20
    Post Likes

    Smile New ECM blower requirement

    Howdy all. Haven't been here in years and decided to visit again. I was curious as to everyone's opinion about ECMs on all new furnaces, repairing, upgrading, etc. I installed a Coleman DGAX070 today with their new ECM. It seemed to move more air than the DGAA did no matter which dip setting I used. Not much info about it in Installation instr. Have to do some research before job finished.
    I hope to visit more often again, I believe I registered in 1999 but couldn't remember my password, but did recall my username.

  2. #2
    Join Date
    Oct 2019
    Posts
    20
    Post Likes
    Thread Starter
    Wow, Robotech still here, Hello Robin

  3. #3
    Join Date
    Dec 2006
    Location
    Vancouver, B.C.
    Posts
    805
    Post Likes
    It says you joined only 11 hours ago....

    Time sure does fly fast!

    You should join into technical conversations to build your post count up then apply for Pro membership (it’s free), so we can get into the nitty gritty with details. We can help you tons more once you are on the pro side.


    Sent from my iPhone using Tapatalk
    Quickly, I must hurry, for there go my people and I am their leader!

  4. #4
    Join Date
    Oct 2019
    Posts
    20
    Post Likes
    Thread Starter
    Ok Thanks tguy, I am still reading rules and learning site protocols again. Ill take your advice.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •