Results 1 to 10 of 10

Thread: Transition

  1. #1
    Join Date
    Oct 2005
    Location
    Seattle, Tacoma
    Posts
    28
    Post Likes

    Transition

    One of the biggest transitions I have built
    Attached Images Attached Images   

  2. Likes Konstantin liked this post
  3. #2
    Join Date
    Aug 2008
    Location
    Hibbing, MN
    Posts
    629
    Post Likes
    That took more than one sheet of tin.
    If God didn't want us to eat animals... He wouldn't have made them out of MEAT.

  4. #3
    Join Date
    May 2006
    Posts
    3,504
    Post Likes
    Nice job i would only have run the wiring for the damper in seal tite looks better but the rest of your work looks really grate

  5. #4
    Join Date
    Mar 2018
    Posts
    34
    Post Likes
    Ladder there adds correct perspective and appreciation of your work. Very professional job

    Sent from my SM-G973U1 using Tapatalk

  6. #5
    Join Date
    May 2006
    Posts
    3,504
    Post Likes
    what is this thing heating or cooling?

  7. #6
    Join Date
    Mar 2005
    Posts
    1,196
    Post Likes
    Quote Originally Posted by pctech View Post
    Nice job i would only have run the wiring for the damper in seal tite looks better but the rest of your work looks really grate
    yes conduit to a box then sealtite
    Keep it simple to keep it cool!

  8. #7
    Join Date
    Mar 2005
    Posts
    1,196
    Post Likes
    Quote Originally Posted by pctech View Post
    what is this thing heating or cooling?
    fresh air
    Keep it simple to keep it cool!

  9. #8
    Join Date
    May 2006
    Posts
    3,504
    Post Likes
    fresh air for what?

  10. #9
    Join Date
    May 2006
    Posts
    3,504
    Post Likes
    Only other thing i would have done unless you did not do them is the damper label should have been on after the pookie was put on the seams its covering part of the label

  11. #10
    Join Date
    Oct 2011
    Location
    Gladstone, Oregon (Portland)
    Posts
    1,253
    Post Likes
    Couple questions. Smacna approved gauge? And were the proper cross-breaks made for that size?

    Just asking because when I was younger we got called out for some of these fittings on large exhaust fans. Cross-breaking wasn't an approved stiffener for the size.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •