Clevland KGT-12-T; Need to source connector for the control box

**Juan Madera** · 04-29-2019, 06:30 PM

Have an old KGT-12T-1 kettle.

Am needing the 10 position edge connector for the kettle control board.

Anyone have a clue where I can get one? Apparently Cleveland is no longer providing that part.

Listed in parts as the WHKGT harness.

(The flame control harness/connector is different and is still available through Fenwal)

Thanks!

**VanMan812** · 04-29-2019, 07:19 PM

PartsTown has 10 in stock. Not sure if p/n WHKGT-2 is different but that’s what came up when I looked up your model. Well, a KGT-12-T. I wonder what’s different about a KGT-12T-1.

Sent from my iPhone using Tapatalk

**Juan Madera** · 04-30-2019, 06:36 PM

Thanks for the lead. Problem is that I cannot see if the connector I need is in that mess...

Had ordered this part # a couple of years ago from Cleveland and it did not have this connector on it. In fact it was just a bundle of wire mostly missing any connectors! Had to solder wire to the board, and now it is pulling lose from the PC board. This is why I again on a quest for the correct part..

**VanMan812** · 04-30-2019, 06:41 PM

Originally Posted by Juan Madera

Thanks for the lead. Problem is that I cannot see if the connector I need is in that mess...

Had ordered this part # a couple of years ago from Cleveland and it did not have this connector on it. In fact it was just a bundle of wire mostly missing any connectors! Had to solder wire to the board, and now it is pulling lose from the PC board. This is why I again on a quest for the correct part..

Is that it on top of all the wires?

Sent from my iPhone using Tapatalk