Hi ,

Anyone know what these setpoints could be ? It sends signals to a HMMV on a brine freezer .Im a power engineer and not familiar with input output setpoints tech stuff lol .Right now both set-points for valve position on the Omron are 00000. Which in turn is not sending the correct signals to the motorized valve on the brine freezer so it can open or close therefore not getting proper ammonia temp of -24 and process temp of -18.
There’s 2 settings out1 and out2 and both are all zeros.This is the first time this has happened so I’m not sure what the initial settings were but it wasn’t zeros . Can .Anyone can tell me what to set these at or where to start at least .hope I made some sense here lol