-
Next level mama
Sent from my iPhone using Tapatalk
-
-
The problem is the bucket is upside down.
Use the biggest hammer you like, pounding a square peg into a round hole does not equal a proper fit.
-
Post Likes - 1 Likes, 0 Dislikes
-
Originally Posted by
firecontrol
The problem is the bucket is upside down.
Yeah but the union to disconnect the drain to get the container out is mint 
Sent from my iPhone using Tapatalk
-
Post Likes - 2 Likes, 0 Dislikes
-
The condensate pump being put into a larger container I've done before. We have a lot of vacation homes here with septic systems that have shallow buried sewer lines leading from the home to the tank. When there is no discharge going down that line all winter long except for the tiny amount of condensate from a furnace the pipe will freeze solid. We sit the condensate pump in a large tote and drill holes in the condensate pump's tank (and sit a brick on top of the housing) to greatly increase the amount of discharge to the sewer. Instead of a quart being pumped, when the float activates it will discharge a few gallons per run making it a lot less likely to freeze the sewer line. We even do this in homes where there is a gravity drain the furnace "could" go into without the need for a pump.
I don't ever remember adding a six pack plastic and .......... what looks to be a pair of tighty-whities in the tub. 
Use the biggest hammer you like, pounding a square peg into a round hole does not equal a proper fit.
-
Post Likes - 1 Likes, 0 Dislikes
-
This was my fix
Sent from my iPhone using Tapatalk
-
Same pump by the way
Sent from my iPhone using Tapatalk
-
Did I miss is...
Looked like the flue pipe on the old 80%-er... was open in the room???
Good looking install!
GA-HVAC-Tech
Your comfort, Your way, Everyday!
GA's basic rules of home heating and AC upgrades:
*Installation is more important than the brand of equipment
*The duct system keeps the house comfortable; the equipment only heats and cools (and dehumidifies)
*The value of comfort, over the long term; leave economic choices behind!
Choose your contractor wisely!
-
Post Likes - 1 Likes, 0 Dislikes
-
Originally Posted by
ga-hvac-tech
Did I miss is...
Looked like the flue pipe on the old 80%-er... was open in the room???
Good looking install!
The metal is just dark
Sent from my iPhone using Tapatalk
-
Damn carrier/bryant doors always misaligned, flimsy cabinets and latches that "sorta kinda" hold the door on. Couldn't they just stamp a few patterns into the sheet metal to make it a little stiffer?
-
Post Likes - 1 Likes, 0 Dislikes
-
There was a water heater next to the RA drop before the fix, did you move the WH?
Those who dance, appear insane to those who do not hear the music.
Those who believe, appear ignorant to those who do not know God.
-
Post Likes - 1 Likes, 0 Dislikes
-
Originally Posted by
cehs
There was a water heater next to the RA drop before the fix, did you move the WH?
Yes. They went outdoor tankless
Sent from my iPhone using Tapatalk
-
Shes a Leaker MOMMA shes a LEAKER MOMMA
he is a good guy for the most part steve lav that is
-
Post Likes - 1 Likes, 0 Dislikes
-
why no intake air from out side like we have to do in my area?
-
Originally Posted by
pctech
why no intake air from out side like we have to do in my area?
It’s in a garage.
Sent from my iPhone using Tapatalk
-
you have it good in certain towns in my state it has to be from the out side no matter what its a pain
-
In GA (state)...
The determining factor is the volume of air in the room the furnace is in...
See the stuff in the IOM manual.
If there is enough volume of air to support combustion... then no outside combustion air is needed.
Personal opinion (supported by NCI): combustion air is COLD... this lowers peak combustion temperature... thus lowering fuel efficiency.
So WHY use outdoor air???
Now up north... the answer is: because the combustion air has to come into the house from somewhere...
And that air is infiltration... which cools the heated air in the house.
Down here in the South... while that still happens... our lows are not that low (most of the time)...
So it is not as serious an issue.
We do not use outdoor combustion air unless it is necessary.
GA-HVAC-Tech
Your comfort, Your way, Everyday!
GA's basic rules of home heating and AC upgrades:
*Installation is more important than the brand of equipment
*The duct system keeps the house comfortable; the equipment only heats and cools (and dehumidifies)
*The value of comfort, over the long term; leave economic choices behind!
Choose your contractor wisely!
-
with the cold and snow you get i can understand why
Reply
Professional Member*
chrisevansac liked this post.
Professional Member*
