Randell custom make table w/ cold rail

[tkav727]

So I’m hoping someone has came across this issue before and knows of a repair other than incorporating a welder. We have a restaurant we service that uses the Randell custom make tables and has all of the cold rails as a system to a remote refrigeration rack. We installed ball valves and confirmed one of the cold rails has a bad leak on it. Is there any way to make a repair on the evaps other than complete unit replacement or using a welder to disassemble everything?

[UmmScott]

No unless u experiment and cut into the side of the rail...but by that point you've torn up the insulation, etc.

I wouldn't recommend it

Sent from my SM-N920V using Tapatalk

[tkav727]

I figured, I was giving it a shot Incase someone figured out something

[VTP99]

Where did you install the ball valves ?

[tkav727]

Right before txv inlet just after LLSV and suction line about 12” or so after exiting evap. It’s a very small area to do any work in about 6” opening

[lytning]

This is a good place to try stop leak. (:-