Page 2 of 2 FirstFirst 12
Results 14 to 15 of 15
  1. #14
    Join Date
    Aug 2015
    Location
    YORK PA
    Posts
    11
    Post Likes
    Seeing 0 volts from the sensor is not good. should be at something. But with out that it should not be logging points. once you get an accurate stall sensor, do not reset the map until you can rerun a point.

  2. #15
    Join Date
    Aug 2006
    Location
    Mixing oil and fire with a big spoon.
    Posts
    6,361
    Post Likes
    I think some are getting confused with the stall sensor and the logging of surges. The sensor used to log surges is not the same sensor used as the stall sensor.
    Don't step on my favorite part of the Constitution just to point out your favorite part.

    Political Correctness is forced on you because you have forgotten decency.

    Technically speaking, they are all heat pumps.

  3. Likes BennyD liked this post
Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.