Page 2 of 2 FirstFirst 12
Results 14 to 16 of 16
  1. #14
    Join Date
    May 2018
    Location
    St.Petersburg
    Posts
    77
    Post Likes
    Thread Starter
    Definitely agree with you on putting the disconnect lower that was my helps genius move. But since he cut into the linset cover where the liquid tight comes out left it there.

  2. #15
    Join Date
    May 2018
    Location
    St.Petersburg
    Posts
    77
    Post Likes
    Thread Starter
    Funny you should say that. The CU was on the roof before but the HO wanted it off the roof so this was literally the only solution to pass inspection, my boss even when down to the city and try to get them to let us out it on the ground. Because it's a stick frame house not block. And if they get termite damage and our CU starts to sag from the wood damage we are the ones getting the cal l, needless to say, city didn't care

  3. #16
    Join Date
    May 2018
    Location
    St.Petersburg
    Posts
    77
    Post Likes
    Thread Starter
    Oh and the "upside down V cut is just black tape to hold the foam in. Gotta keep the rodents out. I take the tape off after the foam dries

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.