Results 1 to 6 of 6
  1. #1
    Join Date
    Feb 2004
    Location
    Nj Pa De
    Posts
    174
    Post Likes

    Yciv stepper valve plug

    Does anyone have part no for cable end/ plug that goes on upgraded ETS stepper valve. The new harness has one end that screws onto valve actuator .other end comes with barbs on 4 wires red,white,black and green. The connector missing is female that plugs into harness from Dan floss stepper control.
    All pic in lit with it show wrong style plug. My plug is square and similar to transducer plugs but with 4 wires.
    The new cable is PTO34G2202A, came in kit with valve ,I can’t even find that number referenced anywhere . Referred as an M12 cable.
    Any help with part no would be great. Thanks
    cant make this crap up

  2. #2
    Join Date
    Aug 2006
    Location
    Mixing oil and fire with a big spoon.
    Posts
    6,308
    Post Likes
    i looked. i didn't find anything.
    Don't step on my favorite part of the Constitution just to point out your favorite part.

    Political Correctness is forced on you because you have forgotten decency.

    Technically speaking, they are all heat pumps.

  3. #3
    Join Date
    Dec 2014
    Location
    New Mexico
    Posts
    804
    Post Likes
    I splice the wires into the old harness, use a good water proof heat shrink. On the smaller chillers pull the cable all the way into the stepper controller and land the wires, you have the new screw connection at the valve.


    Sent from my iPhone using Tapatalk

  4. #4
    Join Date
    Feb 2004
    Location
    Nj Pa De
    Posts
    174
    Post Likes
    Thread Starter
    Yeah I was going to solder splice and shrink wrap. Just thought I’d try and find plug. Not close enough to make it from drain valve to danfoss control. Since completion delayed due to rain I’d thought I’d research plug. But no one seems to be able to find a pic or part no.
    Anyway looks like I’ll be splicing, thanks for looking.
    cant make this crap up

  5. #5
    Join Date
    Jan 2009
    Location
    Jersey
    Posts
    130
    Post Likes

    wiring

    try this,
    Attached Files Attached Files

  6. #6
    Join Date
    Feb 2004
    Location
    Nj Pa De
    Posts
    174
    Post Likes
    Thread Starter
    DFZ that’s some great info.
    However I’m looking for an end that goes on cable from new drain valve into end “ Y “ coming from danfoss control.
    The new cable has 4 barbed ends just need plug to put them in.
    I may order item 002 and 003 just to see , it looks
    cant make this crap up

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.