Results 1 to 5 of 5
  1. #1
    Join Date
    Apr 2005
    Location
    Australia : Queensland
    Posts
    1,845
    Post Likes

    Pocket ir Thermometer.

    What are you guys using for just basic indication of temperature with an ir thermometer ,, I need at least a 6:1 spot ratio & it must fit in my top pocket also. TIA.
    The primary function of the design engineer is to make things difficult for the fabricator and impossible for the serviceman.

  2. #2
    Join Date
    Aug 2014
    Location
    Alberta, Canada
    Posts
    184
    Post Likes
    http://www.amprobe.com/Amprobe/usen/....htm?PID=74757

    My main use for this little guy was to test hanging heaters through factories and warehouses quickly as I walked through. It was fine for that.

    Not really the best- accuracy is so so but served it basic purpose. I have since dropped and broken this unit, which is a bit sad as I liked its size.

    Also the buttons are very small and terrible.

  3. #3
    Join Date
    Apr 2005
    Location
    Australia : Queensland
    Posts
    1,845
    Post Likes
    Thread Starter
    Quote Originally Posted by Choclair View Post
    http://www.amprobe.com/Amprobe/usen/....htm?PID=74757

    My main use for this little guy was to test hanging heaters through factories and warehouses quickly as I walked through. It was fine for that.

    Not really the best- accuracy is so so but served it basic purpose. I have since dropped and broken this unit, which is a bit sad as I liked its size.

    Also the buttons are very small and terrible.

    That should do the job ,,,, only used to see if I'm blowing reasonably cold air at the grilles on AC.
    The primary function of the design engineer is to make things difficult for the fabricator and impossible for the serviceman.

  4. #4
    Join Date
    Apr 2005
    Location
    Australia : Queensland
    Posts
    1,845
    Post Likes
    Thread Starter
    Might be overkill , but I know it's quality ,, this is what I laid my hard earned out for.


    https://www.testo.com/en-US/Paramete.../p/0560%200810
    The primary function of the design engineer is to make things difficult for the fabricator and impossible for the serviceman.

  5. #5
    Join Date
    Apr 2005
    Location
    Australia : Queensland
    Posts
    1,845
    Post Likes
    Thread Starter
    So happy with this purchase.
    Unit does TD also ,,, it has an NTC probe which is great for checking box air-off temps & fits in my pocket.......
    The primary function of the design engineer is to make things difficult for the fabricator and impossible for the serviceman.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •