Results 1 to 3 of 3
  1. #1
    Join Date
    Aug 2006
    Location
    ohio
    Posts
    286
    Post Likes

    Schneider electric tac bacnet controllers

    What software do I need to program/service these controllers. They are set up with a R2 front end.

  2. #2
    Join Date
    Feb 2005
    Posts
    1,661
    Post Likes
    workplace tech, I think the last version was 5.8.x if i remember correctly.
    http://www.controlservices.com/documents/WPT.PDF
    it is very hard to get from schneider dealers but possible.
    read this thread from past:
    http://hvac-talk.com/vbb/showthread....e-availability

    good luck.

  3. #3
    Join Date
    Jan 2003
    Location
    USA
    Posts
    4,941
    Post Likes
    Seen a few customers with it. Must not be impossible.
    Propagating the formula. http://www.noagendashow.com/

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •