+ Reply to Thread
Results 1 to 3 of 3

Thread: Enthalpy Wheel

  1. 03-17-2015, 11:56 AM #1
    crookerr
    crookerr is offline New Guest
    Join Date
    Mar 2015
    Posts
    2
    Post Likes

    Confused Enthalpy Wheel

    I am facilities Manager and I am having an issue with my McQuay Enthalpy Wheel. I have had a few contractors up but they were not able to assess the problem.

    The Enthalpy Wheel gets blown off center to the downstream air flow side when it is turning until it hits the housing then it gets stuck and stops. The unit is only 4 years old and we recently replaced the drive belt. Does anyone know what is going on with this unit?

    Thank you!
    Quick reply to this message Reply   Reply With Quote Reply With Quote
  3. 03-17-2015, 02:35 PM #2
    patpinet
    patpinet is offline Professional Member
    Join Date
    Feb 2010
    Location
    montreal
    Posts
    670
    Post Likes
    Just asking as I'm not sure to have the best answer for you.

    Is the flow still equal on entering side vs exhaust side.?
    As something something changed since the startup?
    Quick reply to this message Reply   Reply With Quote Reply With Quote
  4. 03-17-2015, 02:41 PM #3
    crookerr
    crookerr is offline New Guest
    Join Date
    Mar 2015
    Posts
    2
    Post Likes
    Thread Starter
    You know that is a good question and one that I cannot answer. I will have to get someone in to test it as I do not have a flow meter.
    Quick reply to this message Reply   Reply With Quote Reply With Quote
+ Reply to Thread

Quick Reply Quick Reply

Register Now

Please enter the name by which you would like to log-in and be known on this site.

Please enter a password for your user account. Note that passwords are case-sensitive.

Please enter a valid email address for yourself.

Log-in

« Previous Thread | Next Thread »

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules