Page 2 of 2 FirstFirst 12
Results 14 to 17 of 17
  1. #14
    Join Date
    Jan 2015
    Location
    East Tenn
    Posts
    194
    Post Likes
    Thread Starter
    My Sketch - shows a full Radius going Into the Furnace Also , this was Talked about at great Length , but Their Supervisor didn't
    Past the Information a long very Well or just Thought My Design Sucked , maybe He just doesn't like Me work better then Him .
    Grant It the Full Radius Design Work work might take a little longer to make those 2 pcs. , but My Design actually uses Less Ducting
    and Less Cutting to Connect ( Labor on Site ) ..

    This is what Co-Workers did At Furnace :
    [IMG][/IMG]


    Owner is a little Up Set . .

  2. #15
    Join Date
    Jan 2015
    Location
    East Tenn
    Posts
    194
    Post Likes
    Thread Starter
    This is the Kink in the Lower Flex as it is being Now Pushed back around a Corner and Not brought Straight Into
    My _ Over Under - Dual Barrel Design . . [IMG][/IMG]

  3. #16
    Join Date
    Jan 2015
    Location
    East Tenn
    Posts
    194
    Post Likes
    Thread Starter
    No One has any Photo's of a Great Efficient - Duct to Plume or Plume to Furnace . .

    Really

  4. #17
    Join Date
    Nov 2006
    Location
    Southeastern Pa
    Posts
    32,058
    Post Likes
    Photos of good installs are in the Wall of Pride forum.

    You can edit your post if you do so within a few minutes.

    Welcome.
    [Avatar photo from a Florida training accident. Everyone walked away.]
    2 Tim 3:16-17

    RSES CMS, HVAC Electrical Specialist
    Member, IAEI

    AOP Forum Rules:







Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •