wanted QVM9 quietside parts

[helper777]

Our ministry that helps the homeless and those in need is looking for parts for our QVM9 quietside tankless water heater/boiler. We can't afford a new unit and was hoping someone had an old unit that they took out would have some parts. We are mostly looking for the control board but figure other parts in our unit will eventually go out - so want to plan ahead.
Thank you.

[John Mulder]

I may have some parts on the shelf and possibly another unit to pull out.
What is your location?

[Chuck]

I believe those boilers are under recall, Quietside may compensate you for a new boiler.

http://www.cpsc.gov/en/Recalls/2015/...ters-Recalled/

[John Mulder]

It is the S-line that has a recall to install limit switches. The QVM9 series that we are talking about is a different machine

[helper777]

I wish our unit was under the recall - It would have saved me HOURS of research. I am located in Illinois outside of Chicago.

[Chuck]

I don't usually bash equipment, but quietside is the worst garbage ever to be called a boiler.

You would be best off not spending a penny on it and making a loan for a decent boiler.

[CottageCareRent]

Hello,

I need an air pressure switch for a QVM9. I reside in Haliburton Ontario and am happy to pay extra shipping costs as needed.

Best Regards,

Don

[craig1]

I wish our unit was under the recall - It would have saved me HOURS of research. I am located in Illinois outside of Chicago.

the recall doesn't mean you get a new boiler or a refund. They send out some guy with two limit switches that clip on to the heat exchanger and wire into the high water temp limit.

There is absolutely no support for these. after the recall Samsung spun off the Quietside US boiler division into a sham corporation called Challenger Supply Holdings. They are the support and contact for quietside boilers, but don't answer the phone and have no idea what they're talking about when they do.

[helper777]

We don't have the money to replace the boiler at this time, therefore we are looking for parts.

[diesels]

I am looking for repair parts for the Quietside QXM-8 oil fired boilers. I have quite a few customers who need service. New, serviceable used, and complete boiler wanted. Please reply to this post if you can help. Thanks

[Lorne3458]

I am looking for repair parts for the Quietside QXM-8 oil fired boilers. I have quite a few customers who need service. New, serviceable used, and complete boiler wanted. Please reply to this post if you can help. Thanks

I also have a QXM 8 oil fired boiler,manufactured in 2002, recently it has been shutting down daily. Powering it off and on thankfully restarts it, but the problem is becoming more frequent. The reset button starts it for a few seconds than it stops, red light comes on. My experienced HVAC guy has looked at it and serviced it, he thinks it is probably the control board.

He contacted Quietside they agree it is probably the control board but the board is no longer produced and they do not have any boards. Solution buy a new boiler "OUCH"!

Does anyone have any suggestions as to:
-where I can get the Control board for a QMX 8 oil burner? Or
- is there a replacement control board?

Thanks, love my Quietside, NOT!

[JAMtech]

I may have some parts on the shelf and possibly another unit to pull out.
What is your location?

Any chance you still have parts for a QVW8 quietside heater?

[WI Dude]

I have parts for QVM9. I had total of 4 of them and now all replaced. Used Pats.

[joesac11]

I need dwp 120 pump switch 2060146A

[WI Dude]

I don't see that part # on parts list for QVM9-090/125/150W1-NG

[wioldguy]

I have parts for QVM9. I had total of 4 of them and now all replaced. Used Pats.

I'm looking for an igniter for my QUITESIDE QVM9.

[WI Dude]

I think i have one. They call it
40 C21707133A PH1603008A Electrode and Flame Detection.

What is your e mail i can send you a pic.

[wioldguy]

I think i have one. They call it
40 C21707133A PH1603008A Electrode and Flame Detection.

What is your e mail i can send you a pic.

jmbaribeau@att.net thanks

[rdb75]

I don't see that part # on parts list for QVM9-090/125/150W1-NG

I was wondering if you have a part for the QVM9-090. I am looking for the hot water flow switch. have a customer for this and hit a wall every where i look. any help would be greatly appreciated

[WI Dude]

I was wondering if you have a part for the QVM9-090. I am looking for the hot water flow switch. have a customer for this and hit a wall every where i look. any help would be greatly appreciated

C21213012B BH1408007A Domestic Hot Water Flow Switch (NYLON All QVM9)?

What is your e mail? I will send a pic.

Thanks!