Results 1 to 5 of 5
  1. #1
    Join Date
    Jul 2010
    Location
    Denver, CO
    Posts
    458
    Post Likes

    Trane FPB and Tracer Summit

    I have a Trane FPB that has a failed control board. When I replace this board do I have to address and configure the board in Rover or can I do everything in Summit?

  2. #2
    Join Date
    Jul 2010
    Location
    Denver, CO
    Posts
    458
    Post Likes
    Thread Starter
    I know noone likes Summit, but someone has to know this...

  3. #3
    Join Date
    Jul 2001
    Location
    maryland
    Posts
    1,408
    Post Likes
    what board is in the unit? post a pic if you're not sure.
    Saving the world...one service call at a time.

  4. #4
    Join Date
    Oct 2003
    Location
    On the bay fishing
    Posts
    770
    Post Likes
    I can't stand Summit but your question is to vauge to answer.
    Beware of the prophet trying to make a profit.

    There is less oxygen from knee level to the floor! Check it out next time you tie your boots.

  5. #5
    Join Date
    Apr 2009
    Location
    Denver, CO
    Posts
    35
    Post Likes
    Depends on the type of board. Comm 4 boards can be configured through tracer while the Comm 5 need to be configured in Comm 5 Rover.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •