Search:

Type: Posts; User: Deercooler

Search: Search took 0.02 seconds.

  1. Replies
    6
    Views
    9,099

    Thanks for the reply. I'm not a something for...

    Thanks for the reply. I'm not a something for nothing kind of guy but if memory serves me correct I paid about 30 bucks for the wrench 10 years ago.
  2. Replies
    5
    Views
    1,279

    Yes it has a ZP expansion valve. Compressor is...

    Yes it has a ZP expansion valve. Compressor is not an option on this job, It's a deer processor who got this equip "for a good deal". I said the TEV was stopped up but more accurately not much...
  3. Replies
    5
    Views
    1,279

    Finally 10 Degrees SH

    I've been working on a walk in freezer for the last two weeks(side job). I had to replace a stopped up expansion valve and after 85 clicks out on the service valve wrench I got it FREEZING. I...
  4. Replies
    6
    Views
    9,099

    Service Valve wrench

    I have a yellow Jacket service valve wrench that I bought a few years ago that the gear on the wrench pops out when your in tight spaces. I believe this wrench had a lifetime warranty when I bought...
  5. Replies
    23
    Views
    5,253

    I've NEVER seen one that bad. Seen some sweat but...

    I've NEVER seen one that bad. Seen some sweat but never ice like that.
  6. Replies
    7
    Views
    2,074

    Didn't realize that, thanks for pointing it out.

    Didn't realize that, thanks for pointing it out.
  7. Replies
    7
    Views
    2,074

    Yes I am a Tech. trying to get enough post so I...

    Yes I am a Tech. trying to get enough post so I can post with the grown ups. I would normally replace with the same but the way this one is mounted I don't really like. If it's a 30/55 like the one...
  8. Nope !

    Nope !
  9. And I thought to re-charge a margarita machine...

    And I thought to re-charge a margarita machine you poured more Tequila in it !
  10. Replies
    7
    Views
    2,074

    Fan Delay Defrost Termination switch

    I have a bad one that I have to replace although the Mfg. replacement part is a flat flange mount I prefer the ones that mount on the evap. tubing itself. Any opinions out there would be welcomed....
  11. Thread: X13 motors

    by Deercooler
    Replies
    30
    Views
    27,559

    In most cases unless it's bearing failure you can...

    In most cases unless it's bearing failure you can replace the module on the back of the motor and it works. I installed 4 ICP heat pumps and had to go back and repair 3 of them within 2 years.
  12. It really does look like a P if you put it on...

    It really does look like a P if you put it on that way.
Results 1 to 12 of 13