Search:

I bet it says Goodman on the front of that unit

It's actually incorrect. He should be doing a full Crossbreak or nothing on it. By doing just one side, he is actually twisting the fitting

Me either, up here anything over 1 1/2” connected close to the Boiler like that, we would add a Flex in there for any vibration. No biggie either way, was just a question.....


Sent from my...

Looks like you have a 2in Inline Pump connected directly to the Boiler.....Normally would have a braided flex connection for ani-vibration

No flex on the Pump at the unit?

On the R/A why a change elbow, offset and then a offsetting transiton? You could have had the Elbow, one Transtioning offset and a tap.......

I thought that maybe the case, I will get the installer back out and make sure the swtichs are set correctly. THANKS!

I have a new Carrier Performance series 2 ton 24acc6 16seer A/C and 59tp6 40,000 2 stage gas furnace.

When the A/C runs the system is loud and the air pressure coming out of the registers is very...

Worst part is, that Shit ran that way since 1993

Not wall of pride worth

Is that the vent on the inside corner or the intake?

You KNOW he will not post any of his work, why even ask?

Guys,

I have been in the trade 30 yrs, last 13yrs training estimators how to setup estimating software. So have not been around a lot of equipment for a few years.

Daughter & future son inlaw...

HVAC or Building Maint

WTF is wrong with installers? This guy either has zero experiance or just a Hack in General

No union after the gas valve? Required here for change out.

If its over 2 1/2in Weld it!