Search:

Type: Posts; User: pecmsg

Page 1 of 20 1 2 3 4

Search: Search took 0.30 seconds.

  1. Canít call it black mold without analyzing it! ...

    Canít call it black mold without analyzing it!

    How was the equipment sized?
    Was static pressure checked on the old system?
  2. Replies
    8
    Views
    180

    Get your RH in range then mess with the defrost...

    Get your RH in range then mess with the defrost cycles!
  3. Then call a professional!

    Then call a professional!
  4. Replies
    8
    Views
    180

    감사합니다 Mr Miygi!

    감사합니다 Mr Miygi!
  5. Replies
    17
    Views
    385

    With almost 5000 SQ Ft and 3 systems 1 should be...

    With almost 5000 SQ Ft and 3 systems 1 should be running almost all the time.
  6. *

    *
  7. Or 15#, 50#, 125#.......

    Or 15#, 50#, 125#.......
  8. Pricing is not allowed please remove it. No...

    Pricing is not allowed please remove it.

    No manufacture deals directly with the end user. Its hard enough to deal with allegedly trained techs much less homeowners.

    What's your warranty Parts...
  9. Replies
    22
    Views
    379

    *

    *
  10. Replies
    8
    Views
    180

    Store RH is critical to control freeze ups. Check...

    Store RH is critical to control freeze ups. Check it when its high outside.

    Memory says maintain below 65% but it may have to be lower.
  11. Replies
    40
    Views
    1,811

    NEST used the term...

    NEST used the term Smart......................there's Proof!
  12. So buy a couple of window shakers!

    So buy a couple of window shakers!
  13. Refrigerant leaks can be from day one if proper...

    Refrigerant leaks can be from day one if proper install procedures are not followed.

    Unfortunately sounds like you'll have to wait for a tech to be on site!
  14. and why is your font like this?

    and why is your font like this?
  15. Replies
    6
    Views
    114

    Rip it out and start over!

    Rip it out and start over!
  16. Replies
    33
    Views
    40,591

    You get the Bewbies!

    You get the Bewbies!
  17. Go on the Mitsubishi web site and find a...

    Go on the Mitsubishi web site and find a different contractor.
  18. Caulk

    Caulk
  19. Replies
    40
    Views
    1,811

    How Freeking smart does it have to be? Iím...

    How Freeking smart does it have to be?

    Iím warm turn on
    Iím cold turn off

    Pretty simple to me!
  20. Sounds like thereís still an install issue.

    Sounds like thereís still an install issue.
  21. Replies
    29
    Views
    4,937

    I doubt that!

    I doubt that!
  22. What was the separate issue?

    What was the separate issue?
  23. Replies
    3
    Views
    330

    Curious what: ended up corroding some parts due...

    Curious what:
    ended up corroding some parts due the acids and moisture
    exactly what that was?
  24. Replies
    41
    Views
    2,068

    What?

    What?
  25. Make the installing contractor complete there...

    Make the installing contractor complete there job. Id also request a copy of the start up and commissioning report that "Should" have been done!
  26. Also oversized unit on piss poor ducts and the...

    Also oversized unit on piss poor ducts and the "System" is doing what its designed to, Maintain a minimum static pressure!
  27. Replies
    6
    Views
    114

    Good Luck ...

    Good Luck

    https://icemeister.net/backroom/contents/controllers/comtrol
  28. So what's all that water going to do to the...

    So what's all that water going to do to the condenser coil?
  29. Congratulations you've learned there's a lot...

    Congratulations

    you've learned there's a lot of Buss $hit out there. Even experienced techs can't seem to get it right.

    Now get that post count up and and apply for pro status, correct...
  30. Replies
    33
    Views
    40,591

    02-05-2005, 05:08 PM#1

    02-05-2005, 05:08 PM#1
  31. AHJ

    AHJ
  32. Good Point!

    Good Point!
  33. Replies
    11
    Views
    262

    Run Forrest R U N

    Run Forrest
    R U N
  34. Replies
    22
    Views
    379

    The installing contractor makes or breaks the job!

    The installing contractor makes or breaks the job!
  35. Replies
    3
    Views
    126

    Static pressure readings?

    Static pressure readings?
  36. 1st you have to get samples takin and analyzed...

    1st you have to get samples takin and analyzed too know exactly what mold your dealing with.
    Than you can figure how to deal with it.

    Iíll agree you probably have to replace the unit but can...
  37. Fire Stop Foam. Cut smooth, wood trim.

    Fire Stop Foam. Cut smooth, wood trim.
  38. To rip out the existing condensing unit and...

    To rip out the existing condensing unit and install a heat pump for the shoulder seasons I donít see the benefit. What is he saving 2, 300$ a heating season. Thatís a long pay back.
  39. With Solar I don’t see a return on investment...

    With Solar I don’t see a return on investment changing the outdoor unit. The technology just isn’t there YET to reliably START a heat pump.
    Gas heat in the winter yes. Heat pump / AC no.
  40. Replies
    8
    Views
    402

    Pressure Hi / Low Temperatures Evap Air in /...

    Pressure Hi / Low
    Temperatures Evap Air in / out, suction, liquid, discharge
    Amperage evap and cond motor, compressor
    Voltages
  41. Replies
    4
    Views
    211

    That's a access door, the rod blocks access!

    That's a access door, the rod blocks access!
  42. Replies
    33
    Views
    538

    So increasing the size of the equipment is a...

    So increasing the size of the equipment is a guess at best.
  43. Replies
    33
    Views
    538

    and have they measured static pressure too see if...

    and have they measured static pressure too see if they can handle the increase static pressure?

    NO
  44. Replies
    33
    Views
    538

    Is a properly sized unit matched to the ducts for...

    Is a properly sized unit matched to the ducts for that unit a better solution?
  45. Replies
    31
    Views
    679

    Have you called the manufacturer?

    Have you called the manufacturer?
  46. Well thatís another issue.

    Well thatís another issue.
  47. Replies
    33
    Views
    538

    Is it the A/C or the ducts thatís is causing your...

    Is it the A/C or the ducts thatís is causing your issues?
    If itís the ducts going to 4-Tons is a huge waste of money.
  48. Sweating means the surface is below the dew...

    Sweating means the surface is below the dew point. Raise the due point and the problems goes away.
    Raise duct surface temperature
    Lower RH around the equipment.
  49. Replies
    8
    Views
    402

    Exactly where should the electrical & pressures...

    Exactly where should the electrical & pressures be?
  50. Sensors canít be run with or near high voltage...

    Sensors canít be run with or near high voltage (110 or above)
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4