Search:

Type: Posts; User: RLJN

Search: Search took 0.02 seconds.

  1. Replies
    21
    Views
    925

    As stated above the cond pump is usually the only...

    As stated above the cond pump is usually the only means of venting the entire steam system.
    Any restriction such as this P-trap will impede the air removal.
    Just a vent pipe run straight up would...
  2. Replies
    21
    Views
    925

    Were there any piping instructions with the pump?...

    Were there any piping instructions with the pump? Usually would be. Follow those and you are right......by those standards. AHJ has the final say, no matter how conflicting to those instructions.
  3. Replies
    11
    Views
    858

    It takes at least pump pressure to open the flow...

    It takes at least pump pressure to open the flow check. Closing off the other zones might get it to open with fast fill pressure. I have loosened them by exercising the manual open function several...
  4. Replies
    11
    Views
    858

    Is that PRV open to fast fill? Should hear the...

    Is that PRV open to fast fill? Should hear the flow.
    There might be a manual open on the flow check which could be stuck.
  5. This is just a very expensive Jerry Springer...

    This is just a very expensive Jerry Springer Show..........the cheaper versions are much more educational and enlightening.
  6. If there is a common wall between WIC and WIF...

    If there is a common wall between WIC and WIF even that temp differential is enough to cause water vapor transfer via conduits. Actually any pipe going from inside to outside of a building needs...
  7. Replies
    52
    Views
    3,156

    Is this a gas furnace with the standard 120 VAC...

    Is this a gas furnace with the standard 120 VAC motor or heat pump air handler typically being 208/240 VAC? (some older heat pumps had a single speed for both heat and cooling)
  8. Replies
    76
    Views
    9,268

    Perhaps.... Forced Air Furnace.....

    Perhaps.... Forced Air Furnace.....
  9. Replies
    76
    Views
    9,268

    I have been a licensed electrician for 50 years. ...

    I have been a licensed electrician for 50 years. Moved back to small rural home town 40 years ago wanting to be self employed. Realized this would require more than one trade.
    So learned plumbing...
  10. Replies
    52
    Views
    3,156

    Are the unused speed taps isolated/insulated from...

    Are the unused speed taps isolated/insulated from the power?
    If you somehow energize more than one tap the motor OL would cut out.

    Are voltage, rotation and run cap correct?
  11. Replies
    17
    Views
    1,421

    For a small plug such as this I use the white...

    For a small plug such as this I use the white Teflon paste. Just wipe the top of the container with my finger and then apply around the pipe threads. The brush does too much IMO.
  12. Replies
    13
    Views
    2,869

    If that is a pool heater vented into the same...

    If that is a pool heater vented into the same space, was it running also?
Results 1 to 12 of 13