Search:

i would have to agree with geo man . Ive had 12 carrier wshp that were giving the same symptums and turns out to be water flow issue.

haha alot of over thinking and a crushed supply duct

ive figure everything though thanks

36000 btu not 3600 my bad

CFM=3600/1.08*22.8
CFM=1461

Im getting adequate airflow at the evaportor and at the condenser. My subcooling is close to my target subcooling. I just cant figure out what im doing wrong to get my superheat.

LL pressure:...

When i go to calculate superheat on every unit with the HG2 , once i get result it alway says my temperature is to cold to determine proper charge. And says try raising indoor temperature. Can i...

charge seems low , also what was the water temp coming into your heat exchanger. Pull strainer to make sure you get a good flow through the heat exchanger.

Im having an issue with my t900 thermostat . I have my sensitivity set to 80 and my temperature to 60. When i came in this morning my steam valve wasnt engaging . when i tapped the control it kick...

sorry really late on this but i use my pump wrenches on txv powerheads . They fit just right and they are made by wright tools . For a powerhead 43 i use 1" Service Wrenchw/30deg angle. That wrench...

yea sounds like some type of restriction in the heat exchanger or strainer. Also check the powerhead on the txv and make sure unit isnt kicking out from a freezestat