Search:

Type: Posts; User: targetman

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    1
    Views
    328

    Mitsubishi drive

    Anyone have any experience with this drive. Ever heard of this NexRev? I called them today and they were unwilling to assist with changing a parameter. I told him I would just find out how on...
  2. Replies
    22
    Views
    1,274

    Ditto

    Ditto
  3. Thread: LightStat

    by targetman
    Replies
    5
    Views
    556

    LightStat

    Started a new Job this week. Going to be doing a lot of Retail stores. Never seen one of these till today.
  4. Replies
    4
    Views
    406

    Hands down its Weather King

    Hands down its Weather King
  5. Replies
    7
    Views
    512

    325 psi is way to low of a high pressure cutout. ...

    325 psi is way to low of a high pressure cutout. If you want to know what a HP cutout should be for any refrigerant, you only need to look at the PT chart. Your PT charts list up to 150 degrees. ...
  6. Thread: Walmart EMS

    by targetman
    Replies
    3
    Views
    675

    Thanks. I'll give that a try.

    Thanks. I'll give that a try.
  7. Replies
    2
    Views
    450

    Hoshizaki pump

    I need a water pump for a KM-500MAH. Our parts girl wants to know if I need the motor assembly 0613 or the service kit 0199. I'm not sure so I am asking you guys.
  8. Thread: Walmart EMS

    by targetman
    Replies
    3
    Views
    675

    Walmart EMS

    Hey guys. I'm new to dealing with Walmarts. I have a couple Old Novar controllers that are not enabling dehumidification. I am only getting fan. They are controlling the Munters units. Could not...
  9. Replies
    9
    Views
    700

    Radiant floor heat over existing slab.

    Anyone ever install radiant floor heat over an existing concrete slab?
  10. Replies
    5
    Views
    677

    Ultrasonic testing

    https://www.trutechtools.com/AccuTrak-VPE-1000-Ultrasonic-Leak-Detector-_p_1350.html

    I have been borrowing this tool from another Tech. It's really amazing. I found a leaking schrader valve...
  11. Replies
    34
    Views
    2,927

    I have done half a dozen Jades. The last one was...

    I have done half a dozen Jades. The last one was 5 hours. I remove the old wiring and pull new wire. Take some pride in your work.
  12. Replies
    2
    Views
    888

    Carrier RTU open

    We have several accounts with Carrier rooftops and Carrier controls. The problem is we didn't install or or even work with Carrier controls. So when i get a service call and its not an obvious...
  13. Replies
    18
    Views
    2,241

    Residential? Just buy a new one.

    Residential? Just buy a new one.
  14. Replies
    12
    Views
    2,175

    I think the Sporlan supermarket class is way more...

    I think the Sporlan supermarket class is way more affordable.
  15. Replies
    7
    Views
    1,229

    A couple of out Techs are backflow certified. ...

    A couple of out Techs are backflow certified. They rebuild them all the time.
  16. Thread: Mani S model

    by targetman
    Replies
    1
    Views
    674

    Mani S model

    Well i got called to a Manitowoc today. Rare occasion and I didn't have the Service manual with me. Machine out on #1 fault. Some water in the trough. Start machine up and fills till it hits water...
  17. Replies
    13
    Views
    3,091

    Try replacing the gearmotor current start relay.

    Try replacing the gearmotor current start relay.
  18. Replies
    5
    Views
    998

    Custom curves.

    Custom curves.
  19. Thread: Flashlights

    by targetman
    Replies
    80
    Views
    10,971

    3400mAh battery, fast charger, & nylon holster...

    3400mAh battery, fast charger, & nylon holster for $90.
    https://www.amazon.com/Bundle-Niteco...017KHTJ98?th=1

    This is what i bought and am happy with it so far.
  20. Replies
    5
    Views
    998

    Tekmar replacement

    Current Tekmar 258 doing outdoor reset and controlling 6 stages of heat. I need a replacement. I would like one with a little more flexibility than the Tekmar. Any suggestions?
  21. Replies
    13
    Views
    2,479

    Are you saying that only the Refnets can be used?...

    Are you saying that only the Refnets can be used? I remember something about manifolds.
  22. Replies
    9
    Views
    978

    Taking a new wheel tomorrow.

    Taking a new wheel tomorrow.
  23. Replies
    9
    Views
    978

    Only sparking until I open the door.

    Only sparking until I open the door.
  24. Replies
    9
    Views
    978

    Both problem heaters are common vented with...

    Both problem heaters are common vented with another heater that is operating.
  25. Replies
    9
    Views
    978

    Gas tube heater problems

    I have a Dealership garage with half a dozen old Reznor gas tube heaters. Two of them wont't light unless the access door is open and with the door open the flame rolls out. . Well I can't leave...
  26. Pull and check the inducer.

    Pull and check the inducer.
  27. Replies
    5
    Views
    866

    oops

    oops
  28. Replies
    5
    Views
    866

    1.8 amps with no load. 2.0 amps while making...

    1.8 amps with no load. 2.0 amps while making ice. 2.3 is max.
  29. Replies
    9
    Views
    1,376

    Hose clamp.

    Hose clamp.
  30. Replies
    9
    Views
    1,376

    Purchased at United. Rheem product branded...

    Purchased at United. Rheem product branded Thermal Zone by United.
  31. Replies
    9
    Views
    1,376

    Replacement compressor smaller

    Warranty replacement compressor is a bit smaller than the original. It's a Rheem cube 2 1/2 ton heat pump. Not only is the BTU smaller, but the diameter is smaller as well. The CCH is now to small....
  32. Replies
    1
    Views
    4,577

    Trane thermostat E2

    Going to this call. Customers says E2 on the Trane thermostat. It's a Trane Rtu. No zoning. Any ideas what that E2 means?
  33. Replies
    2
    Views
    3,815

    LG Tech support

    Anyone have a good number/contact? The guy I talked to today was not helpful.
  34. Replies
    2
    Views
    518

    Thanks. That helps.

    Thanks. That helps.
  35. Replies
    2
    Views
    518

    LG touchscreen stat

    How do you enter into the installer setting mode?
  36. We keep track of everything individually down to...

    We keep track of everything individually down to nuts and bolts. We are also expected to inventory our vans on our own time. My opinion is that the small stuff like nuts, bolts, and wire nuts etc....
  37. Replies
    9
    Views
    1,083

    Have you replaced the contactor?

    Have you replaced the contactor?
  38. Replies
    22
    Views
    3,802

    I found the compressor shorted to ground. Notice...

    I found the compressor shorted to ground. Notice the burnt wire on the butt connector in the second pic.
  39. Replies
    22
    Views
    3,802

    Let's get the job done as fast as we can

    This compressor replacement lasted four days. I covered for the guy, but this is the second time similar scenario.
  40. Just get the Bard replacement and be done with...

    Just get the Bard replacement and be done with it. It will look a little different.
  41. Replies
    11
    Views
    1,824

    Medical grade nitrogen

    Anyone using medical grade nitrogen? I have to evacuate some new chiller piping and the job site super is requiring the use of it. Our gas supplier had to special order for it for us.
  42. Replies
    62
    Views
    3,486

    It's a Hobart. Nameplate charge was 21 ounces...

    It's a Hobart. Nameplate charge was 21 ounces 404. The notes left by the Tech who changed the compressor says 2pounds 404. I recovered 2 and a half pounds. Recharge to 21 ounces. Freezer seamed...
  43. Replies
    62
    Views
    3,486

    Reach in freezer

    I worked on this freezer this week. Someone changed the compressor, evap, and cap tube last summer. Why the drier on the discharge line? What is that pvc thing on the evap box?
  44. Thread: Flashlights

    by targetman
    Replies
    80
    Views
    10,971

    That bundle kit looks interesting.

    That bundle kit looks interesting.
  45. Thread: Flashlights

    by targetman
    Replies
    80
    Views
    10,971

    Flashlights

    I need a new flashlight. Not looking for cheap. Must be LED and have a holster. What are you guys using?
  46. Replies
    8
    Views
    2,157

    Is this VRV 4?

    Is this VRV 4?
  47. Replies
    8
    Views
    2,157

    Dry mode lowers coil temp to 43 degrees and fan...

    Dry mode lowers coil temp to 43 degrees and fan goes to low low speed. Have you called tech support?
  48. Replies
    8
    Views
    2,157

    Why are the fan coils in dry mode? What stat do...

    Why are the fan coils in dry mode? What stat do you have? Is there OA ducted to the fan coils?
  49. Replies
    12
    Views
    2,080

    We work on a lot of them. Open up the condenser...

    We work on a lot of them. Open up the condenser coil from the inside for cleaning. Give me a Bard over a Liebert any day. Rock solid IMO.
  50. Thread: Refco

    by targetman
    Replies
    2
    Views
    806

    I asked the Boss to purchase an Inverter checker...

    I asked the Boss to purchase an Inverter checker for me. Refco was the cheapest he could find. He bought one for all the Techs in the company. I know a couple of occasions where other Techs could...
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4