Search:

That’s all I’ve seen is the Danfoss “magic valve” (ICM valve)

Do you borrow your apprentices hammer to beat the magic valve when it’s not working ?:grin2:

Does this rack have a controller? Check the suction setpoint and use a gauge to verify transducer.
This is one of the best manuals out there in my opinion ...

He’s Doug Baldwin in disguise

:bump:

http://hvac-talk.com/aop/

We still have a couple out there. Hard to get parts for them now though.

FKN eh bro

We have done a few conversions now from R22 to R407F . Everything that can leak will leak .CHANGE EVERYTHING WITH AN ELASTOMERIC SEAL. Good luck

Too bad co2 is not a drop in for HP80 :p

Sounds like he has a low pressure oil system. Ive only seen the y1236cs used on high pressure systems. But i do agree you need to pipe the OCV to the higher suction group

Vent into +18 group

Veto mc

The joys of market work.:gah:

Why are you following up on coworkers crap again Mikey? :grin2:

All I know is we have stronger beer

What he said

Pump system down, have new power element on hand , check inlet strainer then inspect power head. Pull it off and see if there's signs of oil in it.
Have you tried to pull the sensing bulb off and...

Doug Baldwin would approve

Yup not a chance I would do that

I believe your talking about a reservoir not a seperator. This is what they call a low pressure oil system. The line going to the suction manifold will have a check valve in it which vents it into...

I don't need no stinkn instructions :whistle:

I had that bite me once , never again

Howdy Mike

You guys need to switch to whiskey

Beer for me now , but the FIL just brought me a bottle of crown royal over. Might have to take a sample

:bump:

All else fails put in a new oven :grin2:

Doug is a man of few words.

Howdy Mike.
I think you scared poor Doug away again

How you been Doug?

Hey Doug

http://digi-cool.com/company-info/contact-us

X7

https://www.ridgid.com/ca/en/hex-wrenches

Actually I'm beginning to think they weren't bitzers. I believe they might of been mycom comps.i wasn't at this job so I don't know for sure. Was a few years ago just trying to remember.

I know we had some issues with some bitzer compressors 50hz not sure what voltage was on it but they didn't get noticed till they didn't work anymore :whistle:

X2

Sorry for your loss.

Thank you sir!

Not to hijack your thread Chuck, but was curious Teddy is this product available in Canada?

X2- I just discovered the exhaust cutter this year it is a slick tool especially for close proximity cutting.

I use these also ...

We use these for All overhead piping and on top of walk-ins

http://www.insuguard.com/insuguard.php

Time to add a new tool to the arsenal. Chainsaw! :grin2:

No it was flooding the system very badly. 200 ft of piping and was frosting back at a couple compressors at the rack. Once I discovered the equalizer line welded shut and fixed that the system was...

I found a 6ft multi deck refrigerated case that was flooding very badly upon startup. (Rack system) and tried adjusting the valve with no improvement. The valve looked like it was pretty cooked from...

:gah:

:LOL:

@ $2250 bucks you should have ordered 2 for a back up meter too

Looks like he started a new thread:anyone: