Search:

Type: Posts; User: BALloyd

Page 1 of 20 1 2 3 4

Search: Search took 0.09 seconds.

  1. Replies
    11
    Views
    215

    Why didn't the required pressure vessel reliefs...

    Why didn't the required pressure vessel reliefs operate???

    Sent from my SM-G965W using Tapatalk
  2. Replies
    24
    Views
    624

    For what reason.....he said they now have an oil...

    For what reason.....he said they now have an oil pump but don't have enough pressure to read for an oil failure??

    What are you getting at???

    Sent from my SM-G965W using Tapatalk
  3. Replies
    24
    Views
    624

    I couldn't tell from the picture that they were...

    I couldn't tell from the picture that they were that small...my bad...

    Sent from my SM-G965W using Tapatalk
  4. Replies
    24
    Views
    624

    Make sure you install an oil failure. Copeland...

    Make sure you install an oil failure. Copeland semi's usually come with a mounting plate for them with a sticker that says something like "Thou shall install an oil failure, or thy warranty is void."...
  5. Replies
    24
    Views
    624

    Where is the oil failure safety for that semi??...

    Where is the oil failure safety for that semi?? Looks like a pressure control in the front but cannot tell...

    Sent from my SM-G965W using Tapatalk
  6. Just because it doesn't say hyper heat doesn't...

    Just because it doesn't say hyper heat doesn't mean it won't heat down to low temps.

    Those Carrier units are rated down to something like -30C. They come standard with a pan heater.

    Sent from...
  7. Replies
    14
    Views
    296

    Fixed it for you. [emoji6] Sent from my...

    Fixed it for you. [emoji6]

    Sent from my SM-G965W using Tapatalk
  8. Standard refiegerant has no odor. Sent from my...

    Standard refiegerant has no odor.

    Sent from my SM-G965W using Tapatalk
  9. My bad then......is that the newest style trap? ...

    My bad then......is that the newest style trap?

    Sent from my SM-G965W using Tapatalk
  10. I have never replaced the gasket on any...

    I have never replaced the gasket on any Carrier/Bryant furnace condensate trap that I have serviced. Likely only needs replacement if it is damaged.

    At least they are removing and cleaning the...
  11. Replies
    4
    Views
    365

    When is the last time your torque wrench was...

    When is the last time your torque wrench was calibrated?

    Sent from my SM-G965W using Tapatalk
  12. Replies
    5
    Views
    438

    Its fine. The blower speed is adjusted by the...

    Its fine. The blower speed is adjusted by the thermostat to match the outdoor unit compressor speed.

    Sent from my SM-G965W using Tapatalk
  13. If they want to install a larger unit just to...

    If they want to install a larger unit just to avoid making some sheet metal transitions...you should run away from that contractor. Run away fast.

    Sent from my SM-G965W using Tapatalk
  14. Replies
    36
    Views
    1,025

    The unanticipated reach around? [emoji16] Sent...

    The unanticipated reach around? [emoji16]

    Sent from my SM-G965W using Tapatalk
  15. Collar size does not indicate correct duct size. ...

    Collar size does not indicate correct duct size.

    10 inch is far better for 600 CFM....

    Sent from my SM-G965W using Tapatalk
  16. Replies
    32
    Views
    1,180

    You have a receiver??..even easier then....pump...

    You have a receiver??..even easier then....pump the system down and charge into the liquid line post receiver...

    Sent from my SM-G965W using Tapatalk
  17. Replies
    51
    Views
    1,839

    Have you tried filling it a second time to...

    Have you tried filling it a second time to confirm it will actually take anymore fuel?

    Might be a sticking fuel sender. Not sure how Toyota units are designed but my Ford truck recently was...
  18. Replies
    27
    Views
    978

    X2. There should be no reason for anyone in the...

    X2. There should be no reason for anyone in the building to be adjusting it if the unit is set up correctly. It won't heat if the outside air is warmer than the setpoint.

    Sent from my SM-G965W...
  19. Replies
    19
    Views
    1,333

    So did you go crazy and see how far over the max...

    So did you go crazy and see how far over the max line you could fill it without spilling?

    [emoji16]

    Sent from my SM-G965W using Tapatalk
  20. Replies
    27
    Views
    978

    I don't see a new gas valve on the list of...

    I don't see a new gas valve on the list of repairs you posted .....

    Did they not update the gas valve when they installed all the new Maxitrols Controls?

    Sent from my SM-G965W using Tapatalk
  21. Replies
    9
    Views
    275

    Ist Lesson.....Ice is like cancer, once it starts...

    Ist Lesson.....Ice is like cancer, once it starts it keeps growing unless treated aggressively.

    If you could still see ice on the coil, guaranteed it is probably built up inside the coil. Standard...
  22. Replies
    5
    Views
    323

    That's not what my Coors Light temperature gauge...

    That's not what my Coors Light temperature gauge said. Those mountains were blue!

    Sent from my SM-G965W using Tapatalk
  23. Replies
    22
    Views
    580

    A flat head on a Robertson eh! Sent from my...

    A flat head on a Robertson eh!

    Sent from my SM-G965W using Tapatalk
  24. Replies
    5
    Views
    323

    A blank sheet of paper is far more useful and...

    A blank sheet of paper is far more useful and valuable than any home inspector report.

    Sent from my SM-G965W using Tapatalk
  25. Replies
    27
    Views
    978

    The mechanical contractor if experienced enough,...

    The mechanical contractor if experienced enough, should be able to set the unit up to maintain a constant discharge temperature.

    This might require a different setup than the unit came with.
    ...
  26. Replies
    27
    Views
    978

    It won't short cycle if it has a properly set up...

    It won't short cycle if it has a properly set up modulating gas valve and controller.

    We don't have enough information to know what set up Engineered Air put in this unit...

    Since it should be...
  27. Replies
    9
    Views
    1,123

    They got part of the coupling so hot it...

    They got part of the coupling so hot it melted....poor brazing technique.

    Sent from my SM-G965W using Tapatalk
  28. Replies
    27
    Views
    978

    Find a different mechanical contractor to examine...

    Find a different mechanical contractor to examine the unit. Call Engineered Air and ask for a recommendation. Their office is in Calgary.

    Sent from my SM-G965W using Tapatalk
  29. Replies
    41
    Views
    1,559

    Roughly calculates to 0.59 ACH....so appears...

    Roughly calculates to 0.59 ACH....so appears tight as balls...

    Sent from my SM-G965W using Tapatalk
  30. Hey Clark....Its September.....no time to worry...

    Hey Clark....Its September.....no time to worry about blondes in Ferraris....shouldn't you be starting to put up your Christmas lights so you will be done in time for December. [emoji6]

    Sent from...
  31. Replies
    41
    Views
    1,559

    He is also at 5000 feet asl, so going to need...

    He is also at 5000 feet asl, so going to need more CFM air flow for the same performance with the less dense air.

    Sent from my SM-G965W using Tapatalk
  32. Replies
    41
    Views
    1,559

    First you need a blower door test done. ...

    First you need a blower door test done.

    Secondly post the results of this duct work testing.

    Sent from my SM-G965W using Tapatalk
  33. Replies
    81
    Views
    1,522

    Yes Sent from my SM-G965W using Tapatalk

    Yes

    Sent from my SM-G965W using Tapatalk
  34. Replies
    81
    Views
    1,522

    Bill....your behind the times....Intel is at...

    Bill....your behind the times....Intel is at currently at 14 and 10 nm for CPU's :grin2:
  35. Replies
    35
    Views
    1,009

    Just for additional comparison, I have a 2700 sq...

    Just for additional comparison, I have a 2700 sq foot house and a 2 ton heat pump, 1350 sq ft/ton.

    Holds 74F at 100F without issue.
  36. Replies
    35
    Views
    1,009

    A large amount of new builds in my area are...

    A large amount of new builds in my area are testing under 1.0 ACH with a target to 1.5 ACH. Based on your results....your house is not really that tight. Lots of opportunity for infiltration.
  37. Replies
    52
    Views
    1,714

    The attached photo is from the installation...

    The attached photo is from the installation manual for your indoor unit. It clearly shows the connections on the main board for the EXV outputs, the pressure transducer and the suction line...
  38. Replies
    38
    Views
    1,827

    You forgot an apprentice to carry all of that...

    You forgot an apprentice to carry all of that stuff...[emoji6]

    Sent from my SM-G965W using Tapatalk
  39. Replies
    13
    Views
    526

    But wait, there's more.... It alsos give you...

    But wait, there's more....

    It alsos give you air conditioning at no extra cost. (Disclaimer....AC uses electricity which is a cost. Lol)

    Sent from my SM-G965W using Tapatalk
  40. I don't see no Sweet Lee's..... Sent from my...

    I don't see no Sweet Lee's.....

    Sent from my SM-G965W using Tapatalk
  41. Replies
    57
    Views
    1,075

    Did you zero it out before or after you cleaned...

    Did you zero it out before or after you cleaned the cocaine off of it? [emoji854]

    Sent from my SM-G965W using Tapatalk
  42. Replies
    57
    Views
    1,075

    Recover to rag...with a WAG on weight.

    Recover to rag...with a WAG on weight.
  43. Replies
    98
    Views
    2,604

    It is not frozen now because it has probably shut...

    It is not frozen now because it has probably shut off the cooling when it reached set point and this off time allowed any ice to melt off the coil.

    Please understand......this system has too...
  44. Replies
    98
    Views
    2,604

    I'd call it "Beaten like a rented mule." Only...

    I'd call it "Beaten like a rented mule."

    Only a matter of time before it keels over if the beating continues.....

    Sent from my SM-G965W using Tapatalk
  45. Replies
    6
    Views
    674

    You are over thinking it..... I have defrosted...

    You are over thinking it.....

    I have defrosted more frozen freezer coils than I care to count. The fastest way period is with hot water and lots of it. Cleaning a freezer coil is not really...
  46. Replies
    16
    Views
    975

    Have you seen some of the apprentices lately?...

    Have you seen some of the apprentices lately? Probably corded to keep them and others safe....

    Sent from my SM-G965W using Tapatalk
  47. Replies
    16
    Views
    913

    RSOB....I believe is Rotten SOB.. Sent from my...

    RSOB....I believe is Rotten SOB..

    Sent from my SM-G965W using Tapatalk
  48. Replies
    98
    Views
    2,604

    As solid as the block of ice on his evaporator. ...

    As solid as the block of ice on his evaporator.

    Sent from my SM-G965W using Tapatalk
  49. Replies
    4
    Views
    623

    I'll start the bidding at $1.00 since it appears...

    I'll start the bidding at $1.00 since it appears to be an auction with no minimum bid.

    Sent from my SM-G965W using Tapatalk
  50. Replies
    6
    Views
    558

    I currently cool 2700 sq feet with 2 tons and it...

    I currently cool 2700 sq feet with 2 tons and it had been in the high 90's here.

    Only proper way to find the right size, as mentioned, is a proper load calculation.

    And as mentioned...the...
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4