Search:

Type: Posts; User: alambi

Search: Search took 0.02 seconds.

  1. I'm used to working on the C602, 708, 606 etc but...

    I'm used to working on the C602, 708, 606 etc but I'm sure the C713 is the same principle.

    When you open the rear cover you should have two contractors. One for the compressor, one for the beater...
  2. Hi, I'm assuming this is a single phase...

    Hi,


    I'm assuming this is a single phase machine?
  3. Replies
    15
    Views
    690

    Call Taylor directly and explain. That's complete...

    Call Taylor directly and explain. That's complete nonsense regarding the warranty. They will make significantly less money claiming warranty from Taylor than they would from you paying.
  4. Thread: Alto Shaam

    by alambi
    Replies
    6
    Views
    472

    Pin is 911 in case this helps anyone else. Thanks.

    Pin is 911 in case this helps anyone else. Thanks.
  5. Thread: Alto Shaam

    by alambi
    Replies
    6
    Views
    472

    Hi Guys, I had trawled through all of these...

    Hi Guys,


    I had trawled through all of these manuals already, but there is no mention of the pin. I'll try 6702 and pray! Cheers
  6. Thread: Alto Shaam

    by alambi
    Replies
    6
    Views
    472

    Alto Shaam

    Can anyone help me out with the service mode pin for the XL xcelerate ovens? There manuals seem to be well guarded!
  7. Replies
    50
    Views
    6,432

    Here in the UK, I have their emails and phone...

    Here in the UK, I have their emails and phone numbers direct. They don't always answer if they're abroad or training as they normally cover EMEA but normally great at responding to emails.
  8. Replies
    15
    Views
    690

    Whats the serial number? M??????? or K???????. ...

    Whats the serial number? M??????? or K???????.


    The fact that it cuts out when its put into freeze mode sounds like a bad compressor, or a faulty mix pump motor. Because it runs ok in wash it...
Results 1 to 8 of 8