Search:

Type: Posts; User: BALloyd

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    8
    Views
    329

    X2. Sent from my SM-G965W using Tapatalk

    X2.

    Sent from my SM-G965W using Tapatalk
  2. Replies
    4
    Views
    421

    This site cannot assist with DIY..... Sent...

    This site cannot assist with DIY.....

    Sent from my SM-G965W using Tapatalk
  3. Replies
    8
    Views
    1,170

    T & M baby! Sent from my SM-G965W using...

    T & M baby!

    Sent from my SM-G965W using Tapatalk
  4. Replies
    13
    Views
    797

    That is the one I have....sorry apparently goes...

    That is the one I have....sorry apparently goes to 2 3/8"

    Sent from my SM-G965W using Tapatalk
  5. Replies
    13
    Views
    797

    Close quarters tubing cutter. I have one that...

    Close quarters tubing cutter. I have one that does 2 5/8" OD.

    Sent from my SM-G965W using Tapatalk
  6. Replies
    7
    Views
    469

    I forgot about those ones...they are slick. ...

    I forgot about those ones...they are slick.

    Sent from my SM-G965W using Tapatalk
  7. Replies
    7
    Views
    469

    Almost everyone I have seen use a small hand lift...

    Almost everyone I have seen use a small hand lift in my area are Genie brand lifts. Ones I have used work well.

    Sent from my SM-G965W using Tapatalk
  8. Replies
    75
    Views
    2,585

    I would partially agree with this, but younger...

    I would partially agree with this, but younger techs also have easy access to far more research and studying materials due to the internet. Not everything can be learned on the job. Sometimes you...
  9. Replies
    139
    Views
    4,874

    Lol....I'll bet Honeywell buys them back...

    Lol....I'll bet Honeywell buys them back now....fixes things and sells them again.

    Sent from my SM-G965W using Tapatalk
  10. What is your inlet gas pressure? What is your...

    What is your inlet gas pressure?

    What is your outlet gas pressure when it tries to open?

    Did you pull the burners and clean them and the crossovers?

    What was the amp draw on the HSI?

    Sent...
  11. Replies
    6
    Views
    1,368

    Sure...until the compressors are murdered..... ...

    Sure...until the compressors are murdered.....

    Sent from my SM-G965W using Tapatalk
  12. Replies
    18
    Views
    510

    You are not following.... Have a new high...

    You are not following....

    Have a new high efficiency furnace installed. They can have to two pipes. One for exhaust and one for direct air intake.

    Then you can foam your attic and avoid any of...
  13. Replies
    18
    Views
    510

    Post the full furnace model number... Sent...

    Post the full furnace model number...

    Sent from my SM-G965W using Tapatalk
  14. Replies
    2
    Views
    249

    You should he able to get parts. I saw a brand...

    You should he able to get parts. I saw a brand new Protocol Remote defrost panel a few months ago...

    Sent from my SM-G965W using Tapatalk
  15. Replies
    5
    Views
    291

    Stop guessing and follow Sporlan's selection...

    Stop guessing and follow Sporlan's selection criteria.....Bulletin 10-10
    ...
  16. Thread: Famous quotes

    by BALloyd
    Replies
    44
    Views
    1,073

    "Nuts" Brigadier General Anthony Clement...

    "Nuts"

    Brigadier General Anthony Clement McAuliffe.

    Sent from my SM-G965W using Tapatalk
  17. Replies
    8
    Views
    562

    I was informed by a reliable source that in...

    I was informed by a reliable source that in Chicago, any equipment with over 5lbs of refrigerant requires a pressure relief.

    Sent from my SM-G965W using Tapatalk
  18. Replies
    11
    Views
    593

    I have found ways to tie them off to units if it...

    I have found ways to tie them off to units if it is windy....

    Sent from my SM-G965W using Tapatalk
  19. Replies
    8
    Views
    562

    Looks field installed and not Mitsubishi to...

    Looks field installed and not Mitsubishi to me....apparently Chicago has some stringent regs..

    I am sure someone who works in the area will see this thread...

    @2sac

    Sent from my SM-G965W...
  20. Replies
    10
    Views
    582

    A lot of issues arise from customers who feel...

    A lot of issues arise from customers who feel they cannot afford downtime. Sometimes this is legitimate and sometimes it is not.

    You would be better off convincing those end users who believe...
  21. You need an HVAC duct company..then can fabricate...

    You need an HVAC duct company..then can fabricate something out of sheet metal

    Sent from my SM-G965W using Tapatalk
  22. I used to have an GMC S series Jimmy with the...

    I used to have an GMC S series Jimmy with the 4.3L. You had to loosen a motor mount and raise the engine just to get the starter out. I would suspect that getting the oil pan off would require the...
  23. Did your techs check if the inducer wheel wheel...

    Did your techs check if the inducer wheel wheel blades are all intact????

    Sent from my SM-G965W using Tapatalk
  24. If it had free puppies included too we might have...

    If it had free puppies included too we might have a deal....

    Sent from my SM-G965W using Tapatalk
  25. Replies
    10
    Views
    506

    He said it was a horizontal installation....so...

    He said it was a horizontal installation....so unless his house blew onto its side.....

    Sent from my SM-G965W using Tapatalk
  26. Replies
    16
    Views
    659

    I am going to suggest another direction at this...

    I am going to suggest another direction at this point. I used to work for a Carrier Factory authorized dealer. We have found and replaced hundreds of these failed secondary heat exchangers, mostly...
  27. Replies
    11
    Views
    1,207

    I got this.... "It worked fine for years." ...

    I got this....


    "It worked fine for years."

    Sent from my SM-G965W using Tapatalk
  28. Who put a return in your kitchen? That is a big...

    Who put a return in your kitchen? That is a big design no no.

    Sent from my SM-G965W using Tapatalk
  29. How do you know VOC's are low? Do you have...

    How do you know VOC's are low? Do you have results to post from an air quality test?

    Sent from my SM-G965W using Tapatalk
  30. Unlikely....you should see the prices of ones...

    Unlikely....you should see the prices of ones that are several years old.

    Sent from my SM-G965W using Tapatalk
  31. This discussion is riveting. Lol Sent from my...

    This discussion is riveting. Lol

    Sent from my SM-G965W using Tapatalk
  32. Replies
    4
    Views
    437

    Freaking grocery stores have burglar bars welded...

    Freaking grocery stores have burglar bars welded in the duct work, never mind a prison.

    Sent from my SM-G965W using Tapatalk
  33. Replies
    5
    Views
    262

    Yep. Twice in the last three months I have almost...

    Yep. Twice in the last three months I have almost had new hood ornaments where pedestrians have tried to enter a crosswalk without looking on a red light for their crosswalk. Ironically no mobile...
  34. Replies
    10
    Views
    960

    Your lucky the anchors in the supports for the 4...

    Your lucky the anchors in the supports for the 4 inch pipe were up to the task...

    Sent from my SM-G965W using Tapatalk
  35. Replies
    78
    Views
    2,115

    Does the K stand for Kinky? Sent from my...

    Does the K stand for Kinky?

    Sent from my SM-G965W using Tapatalk
  36. Replies
    16
    Views
    1,842

    I have never met an iPhone that could take good...

    I have never met an iPhone that could take good close ups of labels....never focus properly.

    Sent from my SM-G965W using Tapatalk
  37. Says it all.812219 Sent from my SM-G965W using...

    Says it all.812219

    Sent from my SM-G965W using Tapatalk
  38. Poll: If Brian GC put as much effort into getting a...

    If Brian GC put as much effort into getting a decent lawyer and filing an appeal as he does arguing his case to a bunch of dudes on an HVAC internet site, he probably would have already gotten a...
  39. Thread: Carrier QC

    by BALloyd
    Replies
    23
    Views
    2,785

    I see quality control sheets that have obviously...

    I see quality control sheets that have obviously been pencil whipped all the time since there are obvious defects. Lol

    Sent from my SM-G965W using Tapatalk
  40. Oh I never said what you are experiencing is...

    Oh I never said what you are experiencing is correct or right.

    I only said, based on what you said about your contractor that did the install, that if you want it done right, then get a balancing...
  41. Poll: Of course you would have grounds to sue....all...

    Of course you would have grounds to sue....all that expensive, technology advanced equipment should never lose a race, no matter who is riding. [emoji6]

    Sent from my SM-G965W using Tapatalk
  42. Replies
    40
    Views
    3,817

    I believe he stated he already weighed in a new...

    I believe he stated he already weighed in a new charge so we can eliminate that.....





    Sent from my SM-G965W using Tapatalk
  43. If you want it done right I would see if you can...

    If you want it done right I would see if you can get an actual balancing company to do it.

    Sent from my SM-G965W using Tapatalk
  44. Replies
    20
    Views
    1,395

    Bite size? [emoji6] Sent from my SM-G965W...

    Bite size? [emoji6]

    Sent from my SM-G965W using Tapatalk
  45. Replies
    5
    Views
    454

    Most of the new ones have safeties that shut them...

    Most of the new ones have safeties that shut them off of they tip over, etc.

    Or get an oil filled electric one.

    Sent from my SM-G965W using Tapatalk
  46. Replies
    7
    Views
    469

    I have never seen a custom SS prep table that had...

    I have never seen a custom SS prep table that had correctly installed refrigeration equipment....always some kind of problem because the lowest bidder installed it.

    Sent from my SM-G965W using...
  47. Replies
    353
    Views
    6,826

    A good boy scout would have equipped his wife's...

    A good boy scout would have equipped his wife's Mercedes with run flats......

    Sent from my SM-G965W using Tapatalk
  48. Poll: https://www.mcmanislaw.com/blog/2018/the-jury-syst...

    https://www.mcmanislaw.com/blog/2018/the-jury-system-a-brief-comparison-between-federal-and-california-practices

    Says California civil juries are normally 12 people and require 75 percent or...
  49. Poll: 10.) The “Common Law” of Negligence: An overall...

    10.) The “Common Law” of Negligence: An overall legal concept based upon California case law and long standing principles of tort law is that every person (in the case meaning both the motor vehicle...
  50. Replies
    4
    Views
    343

    It used a standard 24 VAC signal last time I did...

    It used a standard 24 VAC signal last time I did one of those through the LVTB connections.

    2 out of 3 I did had the stake ones pulled off on the back for some reason. Worked once I fixed it.
    ...
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4