Search:

Type: Posts; User: Bombboy90

Page 1 of 2 1 2

Search: Search took 0.02 seconds.

  1. Replies
    95
    Views
    8,778

    I want to know where people have the weekend...

    I want to know where people have the weekend luxury to clean the van on their time. I’ll clean the van when it slows down or if I have time at the end of the call. It all depends, but either way...
  2. Replies
    21
    Views
    608

    I figured that after I posted. Still seems a bit...

    I figured that after I posted. Still seems a bit scary to me, but then again I havenít dealt with flammable refrigerants yet
  3. Replies
    21
    Views
    608

    I’m no scientist but if we went to r290, wouldn’t...

    I’m no scientist but if we went to r290, wouldn’t a compressor short potentially create an explosion?
  4. Replies
    10
    Views
    719

    If I were to manufacture a unit it would be a...

    If I were to manufacture a unit it would be a York because I love to over complicate EVERYTHING. :gah: I did a heat exchanger with another tech on a York, has to rip half the face off to remove be...
  5. Replies
    10
    Views
    719

    I have seen the seams crack, right on the bottom...

    I have seen the seams crack, right on the bottom of the tube where rust holes are, sometimes found them right off the burner area, and I see them a lot on the crinkled baffles by the inducer. They...
  6. Replies
    19
    Views
    1,104

    Check to see if there are any fibers in the...

    Check to see if there are any fibers in the inducer wheel. I’ve solved many rollout trips on carriers due to huge fiber build up in those inducer wheels. Remove the inducer and take a small flat...
  7. Replies
    19
    Views
    1,104

    .

    .
  8. Replies
    11
    Views
    503

    Doesn’t Comfort Systems USA Just buy up companies?

    Doesn’t Comfort Systems USA Just buy up companies?
  9. Replies
    5
    Views
    357

    Maybe they should stamp/engrave them too. ...

    Maybe they should stamp/engrave them too. Although it says on the box not to remove the cylinder, but who makes a square refrigerant rack anyway. I hope the paint doesnít wear off...
  10. Replies
    52
    Views
    2,002

    The suspense is killing me. Op tell us what the...

    The suspense is killing me. Op tell us what the plate was :gah:
  11. Replies
    27
    Views
    1,921

    :cheers:

    :cheers:
  12. Replies
    26
    Views
    1,640

    Never mix refrigerants per the epa guidelines. ...

    Never mix refrigerants per the epa guidelines. If you ever want to return that mix of refrigerant (407c and 22) you will have to pay to get it incinerated too..
  13. Replies
    8
    Views
    449

    Wish I lived closer. Glad there are still good...

    Wish I lived closer. Glad there are still good people I’m the world.
  14. Replies
    32
    Views
    1,781

    :stinks:

    :stinks:
  15. Replies
    11
    Views
    989

    An ounce of prevention is worth a pound of cure!

    An ounce of prevention is worth a pound of cure!
  16. Replies
    13
    Views
    893

    Are your manifold pressures steady while...

    Are your manifold pressures steady while achieving low flame signal? Did you clean the flame sensor with some steel wool? Maybe the new one is dirty or achieved a film or something. Is the flame...
  17. Replies
    13
    Views
    893

    Is it nat gas or propane? I’m assuming nat gas...

    Is it nat gas or propane? I’m assuming nat gas based on the manifold pressure, but just double checking
  18. Replies
    21
    Views
    2,322

    I had this one call, end of the day call for an...

    I had this one call, end of the day call for an apartment building, dispatch says “Come get the keys to the building, no one is there right now and the call is for no cooling.” I buzz over and I...
  19. Pro membership is free...You’ll have to check the...

    Pro membership is free...You’ll have to check the guidelines then apply. Dems the rules!
  20. Replies
    40
    Views
    2,550

    Agreed. If it runs with the door off maybe you...

    Agreed. If it runs with the door off maybe you have a return issue? Or the attic is so cold and it’s mixing with the bypassed air. What’s the return temp by chance with the door on?
  21. This so true, now you have multiple “bosses”...

    This so true, now you have multiple “bosses” looking over your shoulder! It comes with the drama of the job site, they all have stories, some interesting some not so helpful. I wouldn’t recommend...
  22. Replies
    9
    Views
    600

    I applied for it, haven’t heard anything in...

    I applied for it, haven’t heard anything in while...
  23. Replies
    9
    Views
    600

    It’s from 1978. I wanted the customer to replace...

    It’s from 1978. I wanted the customer to replace and had it on a list, now I’m stuck with the antique
  24. Replies
    9
    Views
    600

    Email address added. Unfortunatly I cannot...

    Email address added. Unfortunatly I cannot confirm the model number due to having no informational tag on this unit. I found those numbers on the door and that’s all I can find so far
  25. Replies
    9
    Views
    600

    I figured it was obsolete. Seems to be the word...

    I figured it was obsolete. Seems to be the word of the year! I was checking carriers website.i am a contractor, but not sure if we have an account with hvac partners. I will look into it. Thanks
  26. Replies
    9
    Views
    600

    Carrier Schematic Search

    Firstly, why is it when you need a schematic and try searching carriers website it seems like they are too embarrassed to acknowledge the existence of the unit youíre working on and provide no...
  27. Replies
    25
    Views
    2,230

    Pull the inducer off and the collection box. ...

    Pull the inducer off and the collection box. Verify there isnít any rust in the heat exchanger tube, and verify that the inducer wheel is clean. I know this is a York but I see wayyyy to many...
  28. Replies
    4
    Views
    1,086

    Ah yes the Fujitsu. I had an issue with one and...

    Ah yes the Fujitsu. I had an issue with one and let me tell you a secret, I have them....Tech support @$@;: me out because I replaced a part without “their” authorization. Good luck with them
  29. Replies
    13
    Views
    1,272

    Still have 24volts where? 24V at the contactor...

    Still have 24volts where? 24V at the contactor in the condenser? What door are you removing? The furnace door or condenser door?

    Assuming you are removing the condenser door and the t-stat is...
  30. Replies
    55
    Views
    4,878

    Thanks for backing me up on this as this is how I...

    Thanks for backing me up on this as this is how I perceived the OP question. My instructor years back refered to 22 as low pressure, 410A high pressure.
  31. Replies
    55
    Views
    4,878

    In my opinion it is all about situation. With...

    In my opinion it is all about situation. With the exception of the r22 phase out. The epa has said r22 is depleting our ozone, hence they are phasing it out and only a few refrigerants work in its...
  32. Replies
    6
    Views
    1,103

    Was it maintenance or service call? What exactly...

    Was it maintenance or service call? What exactly was the split you read? Were the filters and blower wheel clean? And the above posters are right, let it dry even if it’s the evap (yeah yeah I...
  33. Are you paying the shipping? :whistle: Are the...

    Are you paying the shipping? :whistle:

    Are the discharge and suction lines the same size as others have said? Did you re-configure the compressor piping at all? Is it frosting up anymore with...
  34. My opinion is to go on the non metntionable...

    My opinion is to go on the non metntionable social media garage sales pages or another old school ďlistĒ and ask for any old equipment. Reclaim old ac units and scrap them for $$$ for your next...
  35. Replies
    22
    Views
    2,520

    Iím terrified of heights. The very first day on...

    Iím terrified of heights. The very first day on the job nearly 7 years ago in winter the senior tech set up a ladder in the snow and ran up the thing. It took me all I could to work up the courage...
  36. I guess because we are progressive and want to...

    I guess because we are progressive and want to cover our ass Incase anything were to happen. Plus I read that if you reclaim you need to document quantity, name of customer, address, etc but of...
  37. I’ve considered transferring the refrigerant and...

    I’ve considered transferring the refrigerant and evacuating the tank. My only issue is I try to have as pure of a tank as can be and how would we ensure any residue oil is out of the tank? If I...
  38. We account for all reclaimed refrigerant. The...

    We account for all reclaimed refrigerant. The issue we have is that techs will come in grab a virgin tank and reclaim 3# in a 50#er and put it back until they need another which they will grab...
  39. How does your company handle DOT/reclaim tanks??

    Our service manager has tasked me to help handle our reclaimed refrigerant program and as of now itís just a ďfree for allĒ drop of food partial tanks and grab a new one off the shelf:beat:. ...
  40. Replies
    17
    Views
    2,240

    There is truth in this I should’ve rephrased...

    There is truth in this

    I should’ve rephrased it....
  41. Replies
    17
    Views
    2,240

    Awesome! I greatly appreciate the lead, I just...

    Awesome! I greatly appreciate the lead, I just want to get to a point where I don’t have to call any other techs for advice. Thanks techmanterry!
  42. Replies
    17
    Views
    2,240

    Ah but it’s more interesting to hear real life...

    Ah but it’s more interesting to hear real life scenarios of these units! I will try to find some info from the google machine
  43. Replies
    17
    Views
    2,240

    Dectron information wanted

    I am looking to get more versed in Dectrons and Iím having trouble getting any techs to disclose any information where I work. I get the basics of what it does but Iím looking for any literature to...
  44. Replies
    1,071
    Views
    315,493

    That was not the original call I was on, I was...

    That was not the original call I was on, I was suppose to do something different but he insisted I do it. No time or supplies
  45. Replies
    11
    Views
    2,092

    Didn't say I like it! It's too glitchy! But we...

    Didn't say I like it! It's too glitchy! But we use what they provide :whistle:
  46. Replies
    16
    Views
    2,893

    I greatly appreciate your response and I failed...

    I greatly appreciate your response and I failed to mention that I checked rotation each time the draft motor turned on and still read 0"w.c. I even pulled off to check the wheel direction, etc. I...
  47. Replies
    1,071
    Views
    315,493

    Luckily it was a high efficient furnace and that...

    Luckily it was a high efficient furnace and that same condensate line is for the drain of the inducer
  48. Replies
    1,071
    Views
    315,493

    Had a really stupid one, These people had a...

    Had a really stupid one, These people had a company come in to their office and replaced a rtu with a split system in the ceiling. Some company that I don't even know, anyways, he says "there is...
  49. Replies
    16
    Views
    2,893

    I believe it's the heat exchanger but customer...

    I believe it's the heat exchanger but customer said he is going to rip it out and fix it himself so I'm done with it! I just wanted to make sure I wasn't going bat s**t crazy!
  50. Replies
    1,071
    Views
    315,493

    I take care of a place and they have a boiler and...

    I take care of a place and they have a boiler and then an ac system. 2 stats right next to each other on a pillar, one ac, one heat well I get there and they say "the ac isn't working at all!!" I...
Results 1 to 50 of 87
Page 1 of 2 1 2