Search:

Type: Posts; User: BALloyd

Page 1 of 20 1 2 3 4

Search: Search took 0.13 seconds.

  1. Replies
    7
    Views
    230

    I forgot about those ones...they are slick. ...

    I forgot about those ones...they are slick.

    Sent from my SM-G965W using Tapatalk
  2. Replies
    7
    Views
    230

    Almost everyone I have seen use a small hand lift...

    Almost everyone I have seen use a small hand lift in my area are Genie brand lifts. Ones I have used work well.

    Sent from my SM-G965W using Tapatalk
  3. Replies
    11
    Views
    262

    I would partially agree with this, but younger...

    I would partially agree with this, but younger techs also have easy access to far more research and studying materials due to the internet. Not everything can be learned on the job. Sometimes you...
  4. Replies
    50
    Views
    1,325

    Lol....I'll bet Honeywell buys them back...

    Lol....I'll bet Honeywell buys them back now....fixes things and sells them again.

    Sent from my SM-G965W using Tapatalk
  5. What is your inlet gas pressure? What is your...

    What is your inlet gas pressure?

    What is your outlet gas pressure when it tries to open?

    Did you pull the burners and clean them and the crossovers?

    What was the amp draw on the HSI?

    Sent...
  6. Replies
    2
    Views
    623

    Sure...until the compressors are murdered..... ...

    Sure...until the compressors are murdered.....

    Sent from my SM-G965W using Tapatalk
  7. Replies
    17
    Views
    321

    You are not following.... Have a new high...

    You are not following....

    Have a new high efficiency furnace installed. They can have to two pipes. One for exhaust and one for direct air intake.

    Then you can foam your attic and avoid any of...
  8. Replies
    17
    Views
    321

    Post the full furnace model number... Sent...

    Post the full furnace model number...

    Sent from my SM-G965W using Tapatalk
  9. Replies
    2
    Views
    136

    You should he able to get parts. I saw a brand...

    You should he able to get parts. I saw a brand new Protocol Remote defrost panel a few months ago...

    Sent from my SM-G965W using Tapatalk
  10. Replies
    5
    Views
    193

    Stop guessing and follow Sporlan's selection...

    Stop guessing and follow Sporlan's selection criteria.....Bulletin 10-10
    ...
  11. Thread: Famous quotes

    by BALloyd
    Replies
    44
    Views
    833

    "Nuts" Brigadier General Anthony Clement...

    "Nuts"

    Brigadier General Anthony Clement McAuliffe.

    Sent from my SM-G965W using Tapatalk
  12. Replies
    8
    Views
    401

    I was informed by a reliable source that in...

    I was informed by a reliable source that in Chicago, any equipment with over 5lbs of refrigerant requires a pressure relief.

    Sent from my SM-G965W using Tapatalk
  13. Replies
    11
    Views
    459

    I have found ways to tie them off to units if it...

    I have found ways to tie them off to units if it is windy....

    Sent from my SM-G965W using Tapatalk
  14. Replies
    8
    Views
    401

    Looks field installed and not Mitsubishi to...

    Looks field installed and not Mitsubishi to me....apparently Chicago has some stringent regs..

    I am sure someone who works in the area will see this thread...

    @2sac

    Sent from my SM-G965W...
  15. Replies
    8
    Views
    328

    A lot of issues arise from customers who feel...

    A lot of issues arise from customers who feel they cannot afford downtime. Sometimes this is legitimate and sometimes it is not.

    You would be better off convincing those end users who believe...
  16. You need an HVAC duct company..then can fabricate...

    You need an HVAC duct company..then can fabricate something out of sheet metal

    Sent from my SM-G965W using Tapatalk
  17. I used to have an GMC S series Jimmy with the...

    I used to have an GMC S series Jimmy with the 4.3L. You had to loosen a motor mount and raise the engine just to get the starter out. I would suspect that getting the oil pan off would require the...
  18. Did your techs check if the inducer wheel wheel...

    Did your techs check if the inducer wheel wheel blades are all intact????

    Sent from my SM-G965W using Tapatalk
  19. If it had free puppies included too we might have...

    If it had free puppies included too we might have a deal....

    Sent from my SM-G965W using Tapatalk
  20. Replies
    10
    Views
    420

    He said it was a horizontal installation....so...

    He said it was a horizontal installation....so unless his house blew onto its side.....

    Sent from my SM-G965W using Tapatalk
  21. Replies
    16
    Views
    564

    I am going to suggest another direction at this...

    I am going to suggest another direction at this point. I used to work for a Carrier Factory authorized dealer. We have found and replaced hundreds of these failed secondary heat exchangers, mostly...
  22. Replies
    11
    Views
    913

    I got this.... "It worked fine for years." ...

    I got this....


    "It worked fine for years."

    Sent from my SM-G965W using Tapatalk
  23. Who put a return in your kitchen? That is a big...

    Who put a return in your kitchen? That is a big design no no.

    Sent from my SM-G965W using Tapatalk
  24. How do you know VOC's are low? Do you have...

    How do you know VOC's are low? Do you have results to post from an air quality test?

    Sent from my SM-G965W using Tapatalk
  25. Unlikely....you should see the prices of ones...

    Unlikely....you should see the prices of ones that are several years old.

    Sent from my SM-G965W using Tapatalk
  26. This discussion is riveting. Lol Sent from my...

    This discussion is riveting. Lol

    Sent from my SM-G965W using Tapatalk
  27. Replies
    4
    Views
    403

    Freaking grocery stores have burglar bars welded...

    Freaking grocery stores have burglar bars welded in the duct work, never mind a prison.

    Sent from my SM-G965W using Tapatalk
  28. Replies
    5
    Views
    243

    Yep. Twice in the last three months I have almost...

    Yep. Twice in the last three months I have almost had new hood ornaments where pedestrians have tried to enter a crosswalk without looking on a red light for their crosswalk. Ironically no mobile...
  29. Replies
    10
    Views
    796

    Your lucky the anchors in the supports for the 4...

    Your lucky the anchors in the supports for the 4 inch pipe were up to the task...

    Sent from my SM-G965W using Tapatalk
  30. Replies
    78
    Views
    1,993

    Does the K stand for Kinky? Sent from my...

    Does the K stand for Kinky?

    Sent from my SM-G965W using Tapatalk
  31. Replies
    16
    Views
    1,591

    I have never met an iPhone that could take good...

    I have never met an iPhone that could take good close ups of labels....never focus properly.

    Sent from my SM-G965W using Tapatalk
  32. Says it all.812219 Sent from my SM-G965W using...

    Says it all.812219

    Sent from my SM-G965W using Tapatalk
  33. Poll: If Brian GC put as much effort into getting a...

    If Brian GC put as much effort into getting a decent lawyer and filing an appeal as he does arguing his case to a bunch of dudes on an HVAC internet site, he probably would have already gotten a...
  34. Thread: Carrier QC

    by BALloyd
    Replies
    23
    Views
    2,563

    I see quality control sheets that have obviously...

    I see quality control sheets that have obviously been pencil whipped all the time since there are obvious defects. Lol

    Sent from my SM-G965W using Tapatalk
  35. Oh I never said what you are experiencing is...

    Oh I never said what you are experiencing is correct or right.

    I only said, based on what you said about your contractor that did the install, that if you want it done right, then get a balancing...
  36. Poll: Of course you would have grounds to sue....all...

    Of course you would have grounds to sue....all that expensive, technology advanced equipment should never lose a race, no matter who is riding. [emoji6]

    Sent from my SM-G965W using Tapatalk
  37. Replies
    40
    Views
    2,750

    I believe he stated he already weighed in a new...

    I believe he stated he already weighed in a new charge so we can eliminate that.....





    Sent from my SM-G965W using Tapatalk
  38. If you want it done right I would see if you can...

    If you want it done right I would see if you can get an actual balancing company to do it.

    Sent from my SM-G965W using Tapatalk
  39. Replies
    20
    Views
    1,346

    Bite size? [emoji6] Sent from my SM-G965W...

    Bite size? [emoji6]

    Sent from my SM-G965W using Tapatalk
  40. Replies
    5
    Views
    417

    Most of the new ones have safeties that shut them...

    Most of the new ones have safeties that shut them off of they tip over, etc.

    Or get an oil filled electric one.

    Sent from my SM-G965W using Tapatalk
  41. Replies
    7
    Views
    449

    I have never seen a custom SS prep table that had...

    I have never seen a custom SS prep table that had correctly installed refrigeration equipment....always some kind of problem because the lowest bidder installed it.

    Sent from my SM-G965W using...
  42. Replies
    351
    Views
    6,389

    A good boy scout would have equipped his wife's...

    A good boy scout would have equipped his wife's Mercedes with run flats......

    Sent from my SM-G965W using Tapatalk
  43. Poll: https://www.mcmanislaw.com/blog/2018/the-jury-syst...

    https://www.mcmanislaw.com/blog/2018/the-jury-system-a-brief-comparison-between-federal-and-california-practices

    Says California civil juries are normally 12 people and require 75 percent or...
  44. Poll: 10.) The “Common Law” of Negligence: An overall...

    10.) The “Common Law” of Negligence: An overall legal concept based upon California case law and long standing principles of tort law is that every person (in the case meaning both the motor vehicle...
  45. Replies
    4
    Views
    336

    It used a standard 24 VAC signal last time I did...

    It used a standard 24 VAC signal last time I did one of those through the LVTB connections.

    2 out of 3 I did had the stake ones pulled off on the back for some reason. Worked once I fixed it.
    ...
  46. Replies
    9
    Views
    1,073

    Yep. Saskatchewan on this one. Sent from my...

    Yep. Saskatchewan on this one.

    Sent from my SM-G965W using Tapatalk
  47. Replies
    9
    Views
    1,073

    We are controls. This is the mechanical guys...

    We are controls. This is the mechanical guys screw up...who ever that is on this job. I am not there

    Sent from my SM-G965W using Tapatalk
  48. Replies
    8
    Views
    710

    Could you put a very small dab of vacuum grease...

    Could you put a very small dab of vacuum grease on the o-ring???

    Not that you should half to but.

    Sent from my SM-G965W using Tapatalk
  49. Replies
    2
    Views
    787

    Hey....you dropped your brownie! Sent from my...

    Hey....you dropped your brownie!

    Sent from my SM-G965W using Tapatalk
  50. Replies
    9
    Views
    1,073

    New 2 stage with high-efficiency coils

    A guy I work with found this beauty this morning. He went on the roof to see where the new rooftops had been landed yesterday.

    I guess we will have to wait on wiring the controls....at least for...
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4