Threads 1 to 40 of 40

Forum: Motors & Motor Controls

Discussions related to the design, installation, and maintenance of AC and DC motors, and their associated controls

  1. Normal Thread Normal Threads

  2. 11 (not 12) lead dual voltage motor

    Started by Arayt, 04-06-2016 09:19 PM
    • Replies: 3
    • Views: 3,416
    02-23-2019, 09:04 PM Go to last post
  3. Motor for Elevator

    Started by ranitupe, 01-07-2019 12:52 AM
    • Replies: 12
    • Views: 3,211
    01-17-2019, 01:13 AM Go to last post
  4. Hermetic Compressor Motor Issue

    Started by Ryan Babros, 11-13-2018 09:37 AM
    • Replies: 3
    • Views: 1,387
    11-13-2018, 08:03 PM Go to last post
  5. Soft starters

    Started by chander, 06-28-2018 09:50 PM
    • Replies: 4
    • Views: 2,493
    11-04-2018, 01:05 PM Go to last post
    • Replies: 2
    • Views: 1,502
    09-25-2018, 05:16 AM Go to last post
  6. Where to get HVAC fan motor rebuilt?

    Started by valvashon, 04-05-2018 01:35 PM
    • Replies: 3
    • Views: 2,161
    04-07-2018, 05:47 PM Go to last post
  7. Time delay timers explained.

    Started by anthonyac1, 03-31-2018 03:46 PM
    • Replies: 2
    • Views: 972
    04-04-2018, 07:43 PM Go to last post
  8. Finding a motor?

    Started by dingo707, 06-20-2017 07:38 PM
    • Replies: 2
    • Views: 1,246
    06-20-2017, 11:17 PM Go to last post
  9. ABB and fault 16 !!!!!!!

    Started by texast, 06-30-2014 09:41 AM
    • Replies: 10
    • Views: 17,461
    11-16-2016, 09:59 PM Go to last post
  10. Someone experienced in 3ph to single ph conversion ?

    Started by maximusvigor, 10-16-2016 07:24 AM
    2 Pages
    1 2
    • Replies: 22
    • Views: 3,442
    10-24-2016, 11:27 PM Go to last post
  11. Rheostat and hard start kits.

    Started by 2hot4you, 07-18-2016 10:41 AM
    • Replies: 1
    • Views: 2,333
    08-01-2016, 01:40 AM Go to last post
  12. Have you ecer experienced a motor do this?

    Started by Ricky Dale, 05-26-2016 06:27 PM
    2 Pages
    1 2
    • Replies: 20
    • Views: 3,585
    08-01-2016, 01:29 AM Go to last post
  13. Fan cycling switch wire short.

    Started by Clawed worm, 07-25-2016 10:28 PM
    • Replies: 0
    • Views: 1,534
    07-25-2016, 10:28 PM Go to last post
  14. Combustion blower fault

    Started by mockingbird, 07-24-2016 07:42 PM
    • Replies: 8
    • Views: 2,345
    07-25-2016, 04:13 AM Go to last post
  15. 3 phase voltage question

    Started by jmcgreevey, 08-11-2013 11:41 PM
    3 Pages
    1 2 3
    • Replies: 26
    • Views: 11,655
    05-31-2016, 11:32 PM Go to last post
  16. Cooling tower fan minimum speed

    Started by RezAtDorsia, 05-26-2016 08:42 PM
    • Replies: 5
    • Views: 2,314
    05-29-2016, 10:30 PM Go to last post
  17. Yaskawa z1000 drive

    Started by AJS HVAC, 02-29-2016 02:43 PM
    • Replies: 1
    • Views: 2,862
    02-29-2016, 06:36 PM Go to last post
  18. X13 motor constant run!

    Started by CFLHVAC, 04-26-2013 11:15 PM
    2 Pages
    1 2
    • Replies: 23
    • Views: 14,690
    01-07-2016, 04:54 PM Go to last post
  19. Single phase and Three phase motors

    Started by RIEIO, 05-15-2013 12:36 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 12,077
    11-29-2015, 10:15 PM Go to last post
  20. Premium Efficient Motors

    Started by meby, 01-31-2013 05:41 PM
    • Replies: 7
    • Views: 6,685
    10-23-2015, 12:46 PM Go to last post
  21. Motor control issues

    Started by alexanderlev74, 09-02-2015 09:59 PM
    • Replies: 0
    • Views: 3,672
    09-02-2015, 09:59 PM Go to last post
    • Replies: 1
    • Views: 2,374
    08-21-2015, 08:43 AM Go to last post
  22. VFD Enclosures NEMA 3 or NEMA 4 rated enclosures

    Started by airprep, 03-14-2015 01:43 AM
    • Replies: 2
    • Views: 3,215
    03-25-2015, 12:18 PM Go to last post
  23. Counter-Rotating Fan Motor

    Started by ilostmydrink, 12-28-2014 06:21 PM
    • Replies: 1
    • Views: 2,790
    03-07-2015, 07:29 PM Go to last post
  24. VFD on side-grounded delta

    Started by bluke1, 12-17-2014 08:54 PM
    • Replies: 2
    • Views: 2,949
    02-08-2015, 01:02 PM Go to last post
  25. Progremming a VFD

    Started by LMSystems, 12-26-2013 04:40 PM
    • Replies: 2
    • Views: 3,501
    08-09-2014, 10:39 PM Go to last post
  26. Permanent Magnet DC Treadmill Motor

    Started by hurtinhvac, 02-18-2014 01:29 PM
    • Replies: 7
    • Views: 6,510
    02-23-2014, 02:18 PM Go to last post
  27. 1075rpm 1/2hp condenser fan motor bad

    Started by 02JeepKing, 06-16-2013 04:13 PM
    2 Pages
    1 2
    • Replies: 24
    • Views: 10,997
    02-15-2014, 12:59 PM Go to last post
  28. ecm motors can the motor its self be replaced?

    Started by Geo Joe, 01-19-2014 07:59 PM
    • Replies: 1
    • Views: 3,100
    01-19-2014, 09:03 PM Go to last post
  29. Question on a 460V, 3 phase 50hertz pump motor

    Started by seathop, 10-10-2013 09:58 PM
    • Replies: 2
    • Views: 3,590
    12-15-2013, 05:19 PM Go to last post
  30. Why use constant torque ECMs?

    Started by JimtheHVACguy, 07-24-2013 01:40 AM
    2 Pages
    1 2
    • Replies: 13
    • Views: 17,149
    09-25-2013, 10:25 AM Go to last post
  31. Reversing Motor with Drum Switch

    Started by VAV616, 03-20-2013 01:59 AM
    • Replies: 2
    • Views: 4,807
    09-04-2013, 08:31 PM Go to last post
  32. PF Correction Capacitors

    Started by ascj, 07-28-2013 05:08 PM
    • Replies: 6
    • Views: 4,531
    07-31-2013, 09:04 AM Go to last post
  33. VFD For 2 Speed Motor

    Started by The Reaper, 02-28-2013 09:09 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 12,930
    07-26-2013, 02:38 PM Go to last post
  34. ECM troubleshooting

    Started by waterdawg, 07-15-2013 06:32 AM
    • Replies: 1
    • Views: 3,531
    07-25-2013, 03:12 PM Go to last post
  35. VFDs on ungrounded delta systems.

    Started by Randy S., 04-08-2013 09:18 PM
    • Replies: 5
    • Views: 9,041
    07-21-2013, 10:18 PM Go to last post
  36. How to hook up blower motor?

    Started by uncle18, 06-22-2013 12:38 PM
    • Replies: 12
    • Views: 7,498
    06-23-2013, 07:37 AM Go to last post
  37. Hawkeye 458

    Started by blazey10, 05-02-2013 09:59 AM
    • Replies: 2
    • Views: 3,763
    05-12-2013, 10:18 AM Go to last post
  38. Mystery Board

    Started by btucker62, 04-28-2013 11:23 AM
    • Replies: 2
    • Views: 3,613
    04-28-2013, 05:20 PM Go to last post
  39. GE 5KSP39FGW452S Condenser Fan Motor

    Started by Tetracomm, 03-17-2013 11:44 AM
    • Replies: 2
    • Views: 4,105
    03-19-2013, 05:25 PM Go to last post

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 20 replies or 150 views
Hot thread with unread posts
More than 20 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.