I have a gas fired C-64A that is exploding every time the burners try to light on both the wash and rinse sides. It has new ignition control, wire, and igniter on the rinse side. The inducer fan was cleaned, not sure is it is running fast enough or not. This is happening on both the wash and rinse sides.
On start up it sounds like the gas valve is opening but the igniter dose not spark. After about 15 seconds I hear the gas valve click again and the igniter starts and then BOOM! Scares the hell out of everyone in the room.
going to try to get back there today and check gas pressure. It looks like the gas valves have they'er own regulators on them.
If you know these machines any advice would be a big help!