Results 14 to 17 of 17
Thread: Oxy/Acetylene setups
12-17-2011, 09:28 AM #14Professional Member*
- Join Date
- Apr 2009
- Pan Handle, Fl
I set act at 5psi oxy at 10psi and use #2Insanity: Doing the same thing over and over again expecting a different outcome!
12-17-2011, 12:20 PM #15
Check out the Cap'n Hook tips for TXV's and reversing valves. For most brazing I like a B tank with a turbo torch acetylene and air. www.uniweld.com click products, click tips, click specialty tips. Also click air-fuel equipment.Challenge yourself, take the CM test --- Certificate Member since 2004 ---Join RSES ---the HVAC/R training authority ---www.rses.org
12-17-2011, 12:54 PM #16
Has anyone seen this video available at http://www.solderingbrazing.com/ ?
or has been through a training session with Carl Pollex?
Looks like it is a very comprehensive video. Would like feedback though before deciding to purchase.Aircraft Mechanical Accessories Technician. The Air Force changed the job title to Air Craft Environmental Systems Technician. But I've decided I'll always be a Mech Acc.
12-17-2011, 01:23 PM #17Professional Member
- Join Date
- Dec 2011
- Northeast PA