Quadra-fire problem
Results 1 to 4 of 4
  1. #1

    Frown Quadra-fire problem

    My Quadra-fire Classic Bay 1200 Pellet Stove will not keep running. It starts and then very shortly turns itself off. Have done all I can think of and need help, it is getting cold!

  2. #2
    my 1200 is starting fine but then it goes out the pellets quit feeding and the stove goes out. If i continue to hit the reset the pellets feed.

  3. #3

    QUADRA FIRE

    CHECK TO MAKE SURE THE AUGER IS ALWAYS TURNING IN THE RIGHT DIRECTION. YOU MAY HAVE TO STAND THERE AND WATCH IT RUN FOR QUITE A WHILE. IF IT REVERSES, THEN THE CAPACITOR ON THE FEED MOTOR IS BAD. QUADRA FIRE WANTS YOU TO REPLACE THE AUGER MOTOR TO THE TUNE OF $350. I GOT LUCKY, AND THE CAPACITOR WAS EXTERNALLY MOUNTED. REPLACED IT, AND THE STOVE RUNS FINE AGAIN. COST ME LESS THAN TWO DOLLARS, TOOK LESS THAN 5 MINUTES. BUT I SPENT WEEKS TRYING TO FIGURE IT OUT! HOPE THIS HELPS, IT WORKED FOR ME.

  4. #4

    Mount vernon AE pellet stove won't light

    Everything cycles normally - pellets feed, auger works, blower comes on ignition cycle runs but no fire. Could my ignition be bad?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event