Results 1 to 4 of 4
  1. 11-10-2011, 02:42 PM #1
    Miezak
    Miezak is offline New Guest
    Join Date
    Nov 2011
    Posts
    2

    Frown Quadra-fire problem

    My Quadra-fire Classic Bay 1200 Pellet Stove will not keep running. It starts and then very shortly turns itself off. Have done all I can think of and need help, it is getting cold!
    Reply With Quote Reply With Quote
  2. 02-19-2012, 09:45 AM #2
    boneheadhunter
    boneheadhunter is offline New Guest
    Join Date
    Feb 2012
    Posts
    1
    my 1200 is starting fine but then it goes out the pellets quit feeding and the stove goes out. If i continue to hit the reset the pellets feed.
    Reply With Quote Reply With Quote
  3. 02-19-2012, 11:26 AM #3
    Miezak
    Miezak is offline New Guest
    Join Date
    Nov 2011
    Posts
    2

    QUADRA FIRE

    CHECK TO MAKE SURE THE AUGER IS ALWAYS TURNING IN THE RIGHT DIRECTION. YOU MAY HAVE TO STAND THERE AND WATCH IT RUN FOR QUITE A WHILE. IF IT REVERSES, THEN THE CAPACITOR ON THE FEED MOTOR IS BAD. QUADRA FIRE WANTS YOU TO REPLACE THE AUGER MOTOR TO THE TUNE OF $350. I GOT LUCKY, AND THE CAPACITOR WAS EXTERNALLY MOUNTED. REPLACED IT, AND THE STOVE RUNS FINE AGAIN. COST ME LESS THAN TWO DOLLARS, TOOK LESS THAN 5 MINUTES. BUT I SPENT WEEKS TRYING TO FIGURE IT OUT! HOPE THIS HELPS, IT WORKED FOR ME.
    Reply With Quote Reply With Quote
  4. 02-22-2012, 06:08 AM #4
    jerome zazzera
    jerome zazzera is offline New Guest
    Join Date
    Feb 2012
    Posts
    1

    Mount vernon AE pellet stove won't light

    Everything cycles normally - pellets feed, auger works, blower comes on ignition cycle runs but no fire. Could my ignition be bad?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules