Results 1 to 6 of 6
  1. #1
    Join Date
    Dec 2002
    Posts
    81
    Furnace short cycling is frequently mentioned in this forum as not being energy efficient. I have a Honeywell thermostat that can be set to 3 or 6 cycles per hour. (Currently set at 3 cycles). Are either of these considered short cycles?

    Maybe I should have asked if a 10 minute run time is considered a short cycle.

    [Edited by whitedog on 01-30-2006 at 05:49 PM]

  2. #2
    Join Date
    Dec 2002
    Location
    Rochester, MN
    Posts
    5,305
    3 cycles is ideal set point.

    Depends on how cold it is outside, the furnace run time may vary.

    On an avg, I seen about 20 min run time on 3 cph, and about 10 to 15 min down time.

  3. #3
    Join Date
    Jun 2003
    Location
    Florida
    Posts
    9,548
    3 per hour would be 10 min on 10 min off right? That's how I count them...maybe I'm wrong...a Cycle to me is "time on + time off" 6 would be 5 on 5 off . Correct me.
    If everything was always done "by the book"....the book would never change.

  4. #4
    Join Date
    Jan 2006
    Posts
    25
    I'm also interested if 2 stage unit is supposed to run on first stage during these cycles or needs to be partially on 2 stages while maintaining temperature (no change). What's preffered?

  5. #5
    Join Date
    Jun 2004
    Location
    Maryland's Eastern Shore
    Posts
    892
    Anywhere between a smidgen and just shy of a long cycle... Sorry.

  6. #6
    Join Date
    Jan 2003
    Posts
    243
    3 cycles per hour is a good setting. A short cycle would be less than 5 minutes during minimum demand IMO. During extreme outdoor temperatures(depending on design temp), the furance should run nearly constantly. A 2 stage system runs normally on 1st stage, but when extra heat is needed for it to maintain the temp setting, the tstat will bring on the 2nd stage. 2nd stage should only run during peak demand. A normal cycle should consist of a long run on 1st stage.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event