Results 1 to 3 of 3

Thread: Enthalpy Wheel

  1. #1
    Join Date
    Mar 2015
    Posts
    2
    Post Likes

    Confused Enthalpy Wheel

    I am facilities Manager and I am having an issue with my McQuay Enthalpy Wheel. I have had a few contractors up but they were not able to assess the problem.

    The Enthalpy Wheel gets blown off center to the downstream air flow side when it is turning until it hits the housing then it gets stuck and stops. The unit is only 4 years old and we recently replaced the drive belt. Does anyone know what is going on with this unit?

    Thank you!

  2. #2
    Join Date
    Feb 2010
    Location
    montreal
    Posts
    16
    Post Likes
    Just asking as I'm not sure to have the best answer for you.

    Is the flow still equal on entering side vs exhaust side.?
    As something something changed since the startup?

  3. #3
    Join Date
    Mar 2015
    Posts
    2
    Post Likes
    You know that is a good question and one that I cannot answer. I will have to get someone in to test it as I do not have a flow meter.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech365 Virtual Event