Results 1 to 6 of 6
  1. #1

    sheave replacement

    Seeking help or advice with a sheave replacement job assignment on a York packaged unit M-D1EG090N13046E. The RTU with the drive package on the bottom. I might have to fabricate my one puller if I can't fine one that will fit between the shaft end and the base... any help is appreciated.
    Thanks.

  2. #2
    Join Date
    Jul 2011
    Location
    central Alabama
    Posts
    23
    You may have to pull the blower assembly to access the sheave.

  3. #3

    sheave/pulley job

    That is what I was kinda leaning towards as a last resort...... goona look at small pullers and see exactly how much room I have to work with. May end up substituting the jacking bolt furnished with a shorter one, the shaft extension is only about 1.5". I'd make my own puller but I don't have a welder,saw and 1/2" x 2 CRS... but I just might. Hafta see on Monday.
    Thanks.

  4. #4
    Join Date
    Feb 2001
    Posts
    368
    Where ya from in Alabama pion?Montgomery area here.

  5. #5
    Join Date
    Jul 2011
    Location
    central Alabama
    Posts
    23
    B'ham area here

  6. #6
    Join Date
    Mar 2010
    Location
    Kent, WA.
    Posts
    189
    Just pull the blower assembly. no need to wast time and money fiddling around with finding/making a puller. Most of the time the blower assembly is on slides or only 4 screws holding it in.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event