Results 1 to 3 of 3
  1. 08-28-2011, 08:45 AM #1
    rucomfy101
    rucomfy101 is offline Regular Guest
    Join Date
    Feb 2008
    Posts
    13

    Sheave replacement

    Seeking assistance and/or tips on how to replace an indoor fan driven sheave on a York packaged unit, Model # D1EG090N13046E S#NHFM104164.
    An older RTU with the drive components on the bottom with about 4" of clearance to the unit base. The motor sheave is accessible and I will pull the motor if needed, but that driven sheave is tough. If I was in a maint shop I'd fabricate a simple bar puller with some CRS and weld a nut, tap a strongbar and clamps, etc. Any pros out here run into this issue?? Thank you.
    Reply With Quote Reply With Quote
  2. 08-30-2011, 08:41 AM #2
    SouthTex
    SouthTex is offline Professional Member
    Join Date
    Mar 2007
    Location
    South Texas
    Posts
    175
    pull the entire blower assembly out and change it outside the unit,
    Reply With Quote Reply With Quote
  3. 09-03-2011, 07:05 AM #3
    LT1 FUN
    LT1 FUN is offline Professional Member
    Join Date
    Jan 2011
    Posts
    26
    Quote Originally Posted by SouthTex View Post
    pull the entire blower assembly out and change it outside the unit,
    +1 just label the wires so you know where they went
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules