Professional Member*
What is the acceptable leakage rate during a pressure test on a pulse?I.E.1psi in 10 min or less.?I cannot remember & it has been awhile since I have tested one.
Take your time & do it right!
Professional Member*
look in here...
Don't have a lot of time look in this Service Manual maybe it there...Originally posted by markwolf
What is the acceptable leakage rate during a pressure test on a pulse?I.E.1psi in 10 min or less.?I cannot remember & it has been awhile since I have tested one.
http://alltemp-hvac.com/GSR14.pdf
But to be honest I don't think there is an allowable leak rate on a Pulse!
[Edited by AllTemp on 11-01-2005 at 11:03 PM]
AllTemp Heating & Cooling
Regular Guest
Lennox has a new policy...if it's out of warranty...replacew it!Originally posted by markwolf
What is the acceptable leakage rate during a pressure test on a pulse?I.E.1psi in 10 min or less.?I cannot remember & it has been awhile since I have tested one.
Professional Member*
pressurize to 4psi if any pressure after 10 minutes it passes. have not seen a bad one yet that would hold pressure more than about 30 seconds. any small leaks are found on test plugs or spark plug,flame sensor
Professional Member*
Alltemp, why do you have that annoying advertisment and nothing in your credentials?
Posting Permissions
Reply