pulse G 14
Results 1 to 5 of 5

Thread: pulse G 14

  1. #1
    Join Date
    Aug 2002
    Location
    manitowoc wisconsin
    Posts
    4,943
    What is the acceptable leakage rate during a pressure test on a pulse?I.E.1psi in 10 min or less.?I cannot remember & it has been awhile since I have tested one.
    Take your time & do it right!

  2. #2

    Post look in here...

    Originally posted by markwolf
    What is the acceptable leakage rate during a pressure test on a pulse?I.E.1psi in 10 min or less.?I cannot remember & it has been awhile since I have tested one.
    Don't have a lot of time look in this Service Manual maybe it there...

    http://alltemp-hvac.com/GSR14.pdf


    But to be honest I don't think there is an allowable leak rate on a Pulse!

    [Edited by AllTemp on 11-01-2005 at 11:03 PM]
    AllTemp Heating & Cooling

  3. #3
    Join Date
    Dec 2004
    Posts
    441
    Originally posted by markwolf
    What is the acceptable leakage rate during a pressure test on a pulse?I.E.1psi in 10 min or less.?I cannot remember & it has been awhile since I have tested one.
    Lennox has a new policy...if it's out of warranty...replacew it!

  4. #4
    Join Date
    Mar 2005
    Location
    burlington county n.j.
    Posts
    9,686
    pressurize to 4psi if any pressure after 10 minutes it passes. have not seen a bad one yet that would hold pressure more than about 30 seconds. any small leaks are found on test plugs or spark plug,flame sensor

  5. #5
    Join Date
    Mar 2004
    Location
    SE Michigan
    Posts
    17,779
    Alltemp, why do you have that annoying advertisment and nothing in your credentials?
    "Politicians are the lowest form of life on Earth. Liberal Democrats are the lowest form of politician"

    - General George S. Patton

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event