Thank you for all the help on my last post about the Summit. I ran into another prospect that has 48WS heat pumps tied into a Tracer loop controller 2.05

The questions is this. Right now the client only has the panel in the boiler room. I told them that they should install the software on their desk top and then dial in.

Is the client able to get the disk from Trane at no cost or do they need to purchase it.

Client is not sure and either am I. I would hate to tell them that they are elligable when they are not.

Thank you


Ross

P.S. I will take the advice and buy Summit Software. My local trane dist does not play nice. Where should I go to purchase this, how much should it be and last but not least, do they have to sell it to me or can they say sorry charle