Results 1 to 9 of 9
  1. #1
    Join Date
    Dec 2002
    Location
    in a house, Appomattox, Va.
    Posts
    3,255
    Got a bit more work done this week. Set three a/hs, finished the duct for units in mech room. Pics don't to that mass of duct justice, looks like its tied in a big knot! May try a shot from floor.



    refer lines are all guy I work with, I did some tricky fitting together of duct meanwhile.



    Stared this Thursday, 10ish today he finished the lines inside and came out to run some piping.



    Knew this corner was going to give me trouble from day one

    Col 3:23


    questions asked, answers received, ignorance abated

  2. #2
    Join Date
    Sep 2004
    Location
    Memphis
    Posts
    2,502
    Very nice job. I loved how neat that copper runs through the wall. Too bad they dont let yall use a half inch liner on the inside of that duct. All the prints we go by require that. Very nice job.

  3. #3
    Join Date
    Dec 2002
    Location
    in a house, Appomattox, Va.
    Posts
    3,255
    I was looking at those return boxes when I put them in and thinking, that'll be tore up in no time.

    Prints call for 2" wrap throughout the building.
    Col 3:23


    questions asked, answers received, ignorance abated

  4. #4
    Join Date
    May 2000
    Location
    Indianapolis, IN, USA
    Posts
    33,917
    Better get them chained down so you don't lose them

  5. #5
    Join Date
    Oct 2004
    Posts
    1,722
    Nice job. Very nice.
    Get back to work.™

  6. #6
    Join Date
    Dec 2002
    Location
    in a house, Appomattox, Va.
    Posts
    3,255
    They should be safe. Bolted down the minisplits and the condensors are brazed in. GC wanted units on site a week ago and took responsibility for any theft.




    Jail and courthouse are right next door so plenty of "heat" coming and going all the time.
    Col 3:23


    questions asked, answers received, ignorance abated

  7. #7
    Join Date
    Dec 2002
    Location
    Rochester, MN
    Posts
    5,304
    Looks good.. This a Heat Pump system?


    Like to see the pix when you are all done!

  8. #8
    Join Date
    Jul 2003
    Posts
    172
    Whats that lone 3/8 line above the other line sets?

  9. #9
    The last two LL's are not done, so I take it that line is the next LL to be getting installed.

    Nice looking job!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event