Have been working in the trade for 18 months...lol....Have my G2 and ODP card.
I was a Tool and Die Maker in my other life....
Was doing mostly residential work but recently got a job doing commercial / light industrial....WHOLE NEW WORLD...
Hopefully I will get my A/C ticket and then I will be set..5yrs, So much to learn.
Just wanted to say hi and prepare everyone for a barrage of Questions....
I have a fluke 116 meter but now need a clamp meter...any suggestions, Fluke again or maybe a Greenlee...
Thanks in advance to all. Ramhammer
Welcome aboard. Hang on because you can't learn it all in a life time!
Don't worry zombies are looking for brains, you're safe...
(The wise men of modern thought) adore a god made of putty or of wax - plastic, effeminate, molluscous, with no masculine faculty about him, and no quality that entitles him to the respect of just and honest men, for a being who cannot be angry at wrongdoing is destitute of one of the essential virtues, and a moral Ruler who is not angry with the wicked, and who refuses to punish crime, is not divine. ---Spurgeon
My Grandfather was a Tool and Die Maker, if you need a clampmeter that does everything the SC-77 by fieldpiece is a good one. If you just need to read current, ohms and volts I have the Ideal #61-746 it was less than $90.00 at Loew's it is true rms and reads up to 40 million ohms and is catIII 600volt rated. The fluke 902 is one a lot of guys like, kind of spendy and ohms scale doesn't go very high. Welcome Aboard!
Challenge yourself, take the CM test --- Certificate Member since 2004 ---Join RSES ---the HVAC/R training authority ---www.rses.org
welcome, you'll need to get that post count up so when you ask a question the replies will mean something to you ( you'll want to ask technical questions in the pro forums)
It`s better to be silent and thought the fool; than speak and remove all doubt.
The statement below is my signature and just my overall feeling towards our industry and does not necessarily pertain to you nor this thread.
There really isn't a legitimate excuse for not doing the job correctly!