Results 1 to 4 of 4
Thread: PVC MOJO
-
06-12-2005, 10:03 PM #1
Regular Guest
- Join Date
- Jun 2003
- Location
- GA
- Posts
- 395
My PVC MOJO's not as good as I'd like.
What am I looking at on the left of this 90? Is that 2nd HX condensate leaving from the blower compartment area and going down to a floor drain? Is that an air break just above it or a caped clean out? Where is that clear tube going up out of the pic? I see a second PVC tight to the cabent tapping near the bottem of the cabent. Wait a min, that would be the 2nd HX, no?
Sorry that pics as good a view as I have on this VHS tape.
-
06-13-2005, 12:04 AM #2
Regular Guest
- Join Date
- Jun 2003
- Location
- GA
- Posts
- 395
anybody?
-
06-13-2005, 12:42 AM #3
Professional Member*
- Join Date
- Mar 2002
- Location
- Concord, CA
- Posts
- 2,628
I have a feeling this is a trick question. But I'll play along for the moment.
The clear tube looks like the same tubing used on condensate pumps. Since it's coming from higher than the pictured equipment I have to assume it's from another system entirely. Immediately to the right of that is a vent. Presumably they put it there to vent after the furnace's internal p-trap. And of course the PVC appears to go into the furnace to drain the condensate from heater operation.
Troubleshooting by closed circuit televsion are we?
-
06-13-2005, 11:52 AM #4
Regular Guest
- Join Date
- Jun 2003
- Location
- GA
- Posts
- 395
No tricks
No tricks.
T-shoot by CCTV, yes. It's the new thing, I thought you knew. LOL
Reply With Quote